Search results

  1. 91five-o

    Offset Rack Bushings

    My car is lowered approx. 1 3/4 inches. Will a set of poly offset rack bushings help out with bumpsteer, assuming the alignment is right on. Car loves to wander and follow the ruts in the roads. I realize the 9 inch wide rims I have don't help either however for 11 dollars, I thought it would...
  2. 91five-o

    Upper Control Arm Install

    :D Excellent - thanks ! Rick
  3. 91five-o

    Upper Control Arm Install

    One other thing do I need to buy a bushing or somthing for the other end of the control arm? I bought them off ebay but there isnt one with it.
  4. 91five-o

    Upper Control Arm Install

    Thanks. So i dont have to unhook any suspension components like with the lowers. Its just the two bolts on the uppers and thats it?
  5. 91five-o

    Upper Control Arm Install

    Hi I just got bought a set of FMS upper control arms and wantto install them. Could anyone tell me what I have to do to install them. I have installed lowers already now Im on to the uppers. Is the uppers easier then the lowers? Any help would be appreciated. Thanks
  6. 91five-o

    FMS M-5500-A Upper Control Arms.

    :shrug: Anybody have these upper control arms or know anything about them. I have aftermarket lowers and want to replace my uppers. Car is a daily driver with a few runs down the track during the summer. Are these any good or not. I don't think I need to spend a lot of money on the high...
  7. 91five-o

    Upper Control Arms

    Has anybody used or have any experience with the upper control arms sold by FMS, part #M-5500-A. My car is a daily driver with the occasional trip to the dragstrip on ET Streets. Should I forget about these and buy a more expensive set or would these be adequate for my needs. Thanks. Rick
  8. 91five-o

    T-5 Tranny Leak

    :shrug: First trip to the track, first pass, tranny still leaking. I have replaced the rear output shaft seal, tightened all the bolts of the output shaft housing, even drained a little fluid out in case it was overfull(?). Checked the speedo cable connection area - dry around there. Checked...
  9. 91five-o

    Tired Of Draining Radiator

    I'm getting tired of having to drain my rad before I go to the track, then having to add the antifreeze back in when I get home. Is there any other alternatives out there - other than don't race. I would leave the water in it all summer however I have been told this is not a good idea as I...
  10. 91five-o

    I NEED EMISSIONS HELP WITH MY 93 5.0 PLEASE!!!!!!!!!!

    My car failed four times, each time I kept taking more timing out of itand the idle test kept getting better but couldn't get the reading low enough. My car was failing on the idle test only with hydrocarbons. The driving test passed with flying colors the first time through and actually kept...
  11. 91five-o

    need more volts

    :shrug: Thanks for asking, I was wondering the same thing. Is it a simple re and re bolt on job with all wiring the same ? Rick
  12. 91five-o

    Stock tach =good reading?

    At idle my stock tach is accurate. It gets progressively worse (reads high) as the rpms go up. No wonder I kept bogging off the line with my ET Streets. Just wait 'till this year ! :nice: Rick
  13. 91five-o

    Need Help !

    So can I just pull the hoses off or do I need to depressurize the fuel system?
  14. 91five-o

    Need Help !

    I'm a 5.0 guy :D and need some help. My daughter owns a 1997 4.6 GT and needs the fuel filter changed as well as the PCV valve. First off, I can't seem to find the PCV valve so can someone direct me where to look. Secondly, is there anything special about putting in the new fuel filter or...
  15. 91five-o

    Rear Sway Bar

    Thanks. Would this be the same if I had a set of race lower control arms? What I am considering doing is buying a set of race lowers form maximum motorsports with no rear sway bar mount? So with these would it still cause the car to pull one way?
  16. 91five-o

    Rear Sway Bar

    For a daily driver street car would it be ok to remove my rear sway bar and if so how would this affect my car?
  17. 91five-o

    SN95 axels

    Hi I was reading on how the SN95 axels are.75" longer than the 87-93 fox axels. Are each axel .75" longer, or both axels together are .75" longer? Also one other question would these axels be strong enough for the occasional run down the track with ET streets? Thanks Rick
  18. 91five-o

    Lower Control Arms

    Would you be able to buy spherical or the other type of bushing you talked about and replace the polyurethane bushings that come with most lower and upper control arms?
  19. 91five-o

    Lower Control Arms

    I was wondering if anybody has used or knows if the Hotchkis Lower control arms are greasable and if they are any good? Also what are your opinions on the BBK lowers? Just looking at buying some pretty soon and want opinions.
  20. 91five-o

    Slicks

    The tires hook well, I am the part of the equation that's keeping my 60' from being better. I was only cutting a 1.9 and the car was bogging out of the hole. Didn't have time to experiment with launch rpm's as I developed a slight tranny leak and didn't want to push things. Anyway, I...
Top Bottom
Back
Forums
Menu