Search results

  1. F

    Parts store rant

    uhh you used 3/4" heater hose for fuel line :scratch: -1, I forgot to mention I asked them to check 91-93 T-birds, all pulled up the same fox body stuff... There's no independant auto stores around me, they're all chains. There is one good Kragen cuz it's sort of a hub, that's the one I...
  2. F

    How to take off headrests?

    soooo the clip is on the backside of the headrest shaft?
  3. F

    How to take off headrests?

    Ok i'm stumped anyone know how to pull these off? My car is missing the drivers side and i've seen them in junkyards but could not figure out how to pull them off :shrug:.
  4. F

    Parts store rant

    Ok what the **** is wrong with ****ING parts stores these days? Who's the IDIOTs that input the data for the parts, and who's the IDIOTs that decides stocking priorities? I have an easier time finding parts for 30+ year old mopars than I do this 95 mustang... No one makes the flex hoses...
  5. F

    Setting timing

    ya when you got into it it was like ping crazy, I've seen some crazy high timing run before so I think the balancer is fine. It runs like it should now in any case. Well does anyone have any dyno data with WOT timing advance? Part throttle advance is typically much higher than WOT.
  6. F

    Setting timing

    so does anyone know the max WOT advance of the stock computer? Initial + ??? I did time it and I did notice there was no mechanical, I had read on other threads the SPOUT out timing is 10* stock... this one was at 25 :eek:. Set it to 12, it's happier now :D
  7. F

    Setting timing

    ok i'm no newbie to setting timing on older stuff but i'm new to these newer fords... I know there's that little SPOUT jumper that you pull to disable computer control on the timing... but is there actual mechanical advance? What is the factory setting for timing? 34 total? I just got...
  8. F

    The black plastic between the windshield and hood

    you pull the wipers off like mentioned already, then open the hood and the cowl just pops off if you pull gently. Start from one corner and pull up... try not to pop the metal grates off... be wary of the squirter hoses and note how they were routed
  9. F

    Clutch adjustments

    oh? how does one do this?
  10. F

    Clutch adjustments

    :Damnit: ghey....
  11. F

    Clutch adjustments

    Being new to these cars i'm not sure where to adjust the clutch.... I know they use a cable, but do you adjust your pedal freeplay in the interior or at the trans? Right now I have a car that has too much engagement, needs a little more freeplay.
  12. F

    Taking off factory fuel hoses

    ok then :nice:. Anyone know where to find replacements?
  13. F

    Taking off factory fuel hoses

    hmmm that sounds plausable can anyone confirm?
  14. F

    Taking off factory fuel hoses

    Just like the title says, I know how to take off the rail side of the hoses with the push-in plastic clips but not so sure on the side that goes to the metal lines by the firewall. One is obvious, it has a tab you pull out and can pull the line off, but the other has some kinda tangs sticking...
  15. F

    Smoking Cats

    ? :D
  16. F

    How big is our gas tank?

    what should a bone stock 5 speed do?
  17. F

    Replacing Ignition Lock Cylinder

    what if you don't have the original key? :(
  18. F

    stupid cheap as$ lugnuts

    had the same thing happen before, take all the lugnuts you can off and pull on the rim as you unthread it... if that fails try an impact... use anti-seize in the future:nice: lol thats the lugs I had the problem with
  19. F

    Replacing Ignition Lock Cylinder

    I might be doing the same thing in the future as well, so how does one get the ignition lock out?
  20. F

    Are our cars REAR ABS?

    :eek:
Top Bottom
Back
Forums
Menu