Search results

  1. 1988WHTGT

    Savannah Area Tuning?

    Anyone have any good places to go to get tuned kinda close to Savannah? My mods are in my sig.....do I just need a chip for tuning? Don't have a whole lot to spend, but want to get the car kind of running right!
  2. 1988WHTGT

    Timing Problem

    This thing still barely has any fuel pressure according to the gauge. I'm going to try a new fuel filter tomorrow and go from there =(
  3. 1988WHTGT

    Timing Problem

    Ok, I just tried this with a test light and jumper wire. The light on the test light is kind of dim with the key and gets bright with the key on but does not blink any. Do I have some major problems?
  4. 1988WHTGT

    Wiring switch for E-Fan

    This is driving me crazy! I have a Proform e-fan that I'm wiring up. I have everything but a key-on power source. The switch is in the cubby-hole under the radio. What should I tap into for this? Thanks!
  5. 1988WHTGT

    Timing Problem

    How would I do that?
  6. 1988WHTGT

    Fuel Pressure Issues

    Anybody? I put a new IAC on it yesterday (had a surging idle). Still only showing 10psi of fuel pressure. It was surging BAD this morning. Idles between 500 and 2200 RPM. My main thing right now is figuring out this fuel pressure thing though.
  7. 1988WHTGT

    Fuel Pressure Issues

    I've been trying to get my car running good and noticed my fuel pressure is low. I have a Kirban AFPR, fuel pressure gauge on the rail and a 255 pump. My pressure at idle is sitting at about 10 psi. I tried adjusting at the regulator and nothing changes (vacuum line is off and plugged)...
  8. 1988WHTGT

    Timing Problem

    Spout connector was in and it wasn't advancing. Also notice another weird thing....it will sit and idle in neutral fine, then I push the clutch in and put it in in gear it revs up for a second and then idles a little higher than before. Do I just have all kinds of problems? ha
  9. 1988WHTGT

    Timing Problem

    I've been trying to figure out why my car has been running like crap. Went and checked the timing today. It was at 15 degrees (spout connector unplugged). When revving it, it just stays at 15 degrees and is not advancing. What could be wrong?
  10. 1988WHTGT

    Which Gasket?

    I had an intake gasket go before and it was kind of like this. But, I sprayed carb cleaner all around where I could reach last night and it didn't do anything. I'll check the PCV. What else could it be?
  11. 1988WHTGT

    Will someone tell me the proper way....

    ....to install new lower intake gaskets (lower to heads)? I need to know the best way to approach it, the torquing order, where to use rtv and what kind etc. I need to do this this weekend. Please help! Oh, and I guess I'm going to use Fel-Pro 1250's (Professional Products Typhoon Intake and...
  12. 1988WHTGT

    Which Gasket?

    Do you use anything on the intake bolts when putting them back in? Does anyone have a writeup on the best way to do this?
  13. 1988WHTGT

    Which Gasket?

    Thanks! Does that sound like what my problem is?
  14. 1988WHTGT

    Which Gasket?

    So I think I have a bad lower intake gasket. When I put my hand over the oil fill hole its sucking air and it idles high. I have the Professional Products Typhoon intake. What gasket sets and numbers should I use? Thanks!
  15. 1988WHTGT

    Argh....Stupid Idle issue

    Ok, I went through the surging idle checklist. I've tried everything. On a cold start, the car starts up fine and then idles down after a couple of minutes. On a hot start, the car won't start if I don't push the gas pedal down. Then when it does start, the idle jumps between about 600 rpm...
  16. 1988WHTGT

    1988 Mustang GT TKO 500 Install Questions

    I'm just using the stock aluminum tremec bellhousing
  17. 1988WHTGT

    1988 Mustang GT TKO 500 Install Questions

    I have everything needed. Tranny, bellhousing, slip yoke, new clutch, aluminum flywheel, fluid etc. I know I have to modify the crossmember. My main question is....the car has longtubes on it. 1 5/8". Am I going to have to take these damn things off to put the tranny in? I'm hoping I won't have...
  18. 1988WHTGT

    What should I do about a transmission?

    I've destroyed by 3rd World Class T5. I can't keep doing this. The car is making 315 hp and 330 ft/lbs of torque to the rear wheels. I'm going to keep it manual, so what should I put in it? G Force T5? Tremec TKO500 or 600? I can't spend a ton of money on it either, for example, $2500 is...
  19. 1988WHTGT

    BBK CAI Hoses?

    I have the BBK fenderwell CAI without the rubber hoses for attaching it to the throttle body and the MAF meter. Is there anywhere to buy these or should I just go get some hose and make it work?
  20. 1988WHTGT

    Weird Problem...I need some help...

    Ok, if I'm going down the road in 4th or 5th gear (probably around 50 mph) the car will start to jump some and act like i'm letting off and on the gas. It finally irritated me enough to where i pushed the gas to the floor while it was doing it. Nothing happened at all. Did rev up or anything...
Top Bottom
Back
Forums
Menu