Hi Guys,
Hoping for some help. Getting ready to get my vehicle approved, roadworthy (safety check) and registered and have a tight time lime to do this.
Worst luck ever, removing the old temperature sensor which was in tight...as it loosening I here some bubbling and when I remove it I see a...
Hello,
About a month ago I purchased an engine from Rock auto that was semi complete to replace one that had died. This engine is a 2002 4.6L for a GT. As you can clearly see in the photo the cam bearing saddle has a pretty huge crack. I have not ran it yet, and I am not sure I should. What are...
Going to be removing my passenger side exhaust manifold due to it being cracked completely in half right above where the flange connection is, managed to remove the 6 nuts fastening the manifold to the block , and the top egr bolt, but I can't seem to reach the lower egr bolt or the two bolts...
Hey everyone. I'm new to the forums and trying to find my way as I go, so bear with me. (I tried searching all the threads before posting because I realize starting a new thread on something that's already been addressed is exceedingly frustrating, however I found nothing). I'm looking at buying...