I was just given some “Brodix BP ST 5.0 R Series Cylinder Heads CNC Ported” by a friend and was wondering how these would fare on a SD car? So far my 87 Notch has a 306 with mods that include Intake, BBK 70mm Spacer and TB,BBK long tubes,BBK Off Road Cats with X pipe to stainless piping with...
I'm wondering how difficult it is, to remove the cylinder heads. Without taking out the engine.
I want to port and polish them, but I don't have the ability to take the engine out myself. Nor do I really want to pay someone to do this stuff for me.
Mainly I'm concerned with the timing chain...
I recently got a thunder bird. It has the w for the 8th digit on Vin. I know it as a 2v 281 Romeo non pi motor. What pi heads go with this motor. A gentleman right down the road has a 07 police interceptor motor. Now, 1 how interchangeable are the heads on the 4.6 modular engines. 2 I want...
I'm getting desperate at this point.
So, I had bad compression in two of my cylinders and my car drank coolant before I started this job nearly two months ago, so figured I would check the head gaskets. I have never had this engine open since I got the car. At the same time, I pulled some GT40p...
Hi I have a sn95 cobra i just got as my first car and am very interested in building it to a 347 down the road. I have experience in building engines just not anything serious mostly stock or small. Was wondering if someone could explain to me how to tell if a cam would work/fit in an engine...
///Sold///
Listed is a Ford Motor Company (FoMoCo) head for a Ford 260 V8. This head is identified as C4OE-O and includes valves, valve Springs, retainers, etc. assembled. The date code on both heads is 4F19 (June 19, 1964), so the intake valve is understood to be 1.67 and the exhaust valve is...
[SOLD]
Listed are a pair of Ford 351C 2V Cleveland 2 Barrel Cylinder Heads that have been cleaned up and include some preparations for screw in studs and guide plates as well as some light porting work.
351 - 2BBL (FORD Part number D1AE-CB)
Date Code 2J29 equates to September 29, 1972
Date Code...
Hello my name is nathan and im starting to do a restoration on a 1989 mustang, body is in the shop getting work and new paint so i am taking apart the motor to have cleaned, and machined as well as stroked to a 347 and i was looking at aftermarket heads and the question i have is the two choices...
ive been looking around trying to find a decent cam with i good sound but not too aggressive and also gives me good performance. i have the 94 gt and was seeing a lot of people getting the E303 cam vs something from trick flow or comp cams. first id like to know why, secondly id like to know if...