eec

Replacing the capacitors in your Fox Mustang EEC? Here is the quick and dirty info you need so that you don't have to look all over the place like I did. I watched every YouTube vid I could find on replacing these 3 caps. I also watched plenty of “how to replace capacitors” in general. I have...

Used Moates QuarterHorse, works perfectly. Comes with remote USB terminal and regular usb tuning cable. Works on 2004 and older Ford EEC computers. $190 shipped lower 48. Highland, Indiana

Hi All! I am a new member here, but I confess I have been lurking since I bought an 89 GT 5-speed convertible a year ago (wife says it's my "mid-life crisis car") There's some great tech advice on here! Hope someone can help with this issue. The fuel pump runs constantly with the key on...

Hello All, New here. Ill do my best to explain the situation. Bought a 1987 Thunderbird for my brother. The car was originally a 5.0 non-HO. The previous owner swapped in a 5.0 HO out of a 1992 fox body and a AOD trans. He also swapped in the A9P eec without doing any harness changes. The...

Hello! This is my first post on StangNet. I've done plenty of lurking and searching to find lots of helpful information, this place is amazing! Before someone posts "Search it.", I have. Please read on. My car (1989 5.0 LX) has been having lots and lots of electrical issues. I've come to what...

I have a '95, base model, 3.8l mustang. Over a year ago I was having problem where, I would accelerate and car would start going, lose all power for a second, go, lose power, come close to stalling and so on usually 3-4 times. Lost all RPM's, speedometer bouncing, all gauges bottomed out and...

Howdy All, Haven't found much on the online re an intermittent issue I have been having.. Sometimes there's a rapid constant clicking coming from the area of the EEC. It has happened with key on engine off, with KOER, and after turning over the engine when I can't get it to start (in all cases...

I have a Tweecer RT for sale, this is the same one i used to help reverse engineer the RT lib for Binary Editor .. I no longer do much with cars anymore.. If i do , i can always just buy a new one :) or go MegaSquirt. Must Have for Any Do-It-Yourselfer! Pardon the picture, the Tweecer is...

Hey gang, I have no continuity between pins 46 & 40/60 on eec connector, so I pulled the eec to inspect. After inspecting both sides of the circuit board, I saw no obviously fried circuit to go ahead and jumper (as has been the case for others). The only obvious issue was a leaking capacitor...

Hey gang, Is there a list/reference that gives normal specs for when checking eec pins with multimeter? I tested all eec pins' resistance with known ground (battery disconnected) and got what i suspect are some abnormal readings for several of them (all eec grounds seem fine though)...