#rebuildissues #sn95 #motorrebuild

New here, over the course of the whole COVID quarantine I did a rebuild on my ‘02 gt. I got it to start but realized that I needed to put an adjustable ball pivot stud in my trans because of the stage 3 clutch I put in it. Pulled the motor and trans again to fix this issue. In the mean time I...

Hey there, I have a 2011 4.6l pi motor out of crown Vic that I am building for my mustang. That being said I was going to bore the block but I’m going off to school soon and need to get the swap done and save a little money before I go. I’m looking for a forged rotating assembly for the 289 that...

Hey so I got a 1998 mustang gt almost two years ago, I’ve had almost everything replaced/fixed from the head gasket being blown, bad water pump, radiator, spark plugs, fuel pump, thermostat , new radiator hoses, tires, new steering column, drain plug, the car came with a 3.6 l fan(idk y the last...

Hey hows it going guys, I just did a full rebuild on my 1994 Mustang 5.0 about 6 months ago, it is the first time i have rebuilt a motor, and am having some issues after the rebuild. Here is what the rebuild consisted of so you can get an idea of what was done to the car, and then ill go on to...