roller block

  1. 6

    Hey all,I’m putting together a 302 for my 1968 Mustang and wanted to post the combo + some questions to make sure I’m not missing crucial

    Goal: fun street car, ~6,000 rpm max, T-5, 3.55 gears. I had a 68 flat tappet 302 in it originally with a gnarly cam, so I want the bay to still have the same look. (V-belts, early timing cover and pump), but using a roller 5.0 short block and better top end. Carb for now, Holley Sniper EFI...
  2. RotFox90

    Engine *Block Question-is it the same spec*

    Hey all, I’m searching for a block to start a build & just had a question; will a block out of a ‘94 fit into my ‘90? Just so happened to be the first one I found, and it is JUST the block. Such as engine mounts, mounting to AOD, head fitment…
  3. 8

    Engine Piston Identification Help(Roller 5.0)

    Hey there guys, new to the forum. Excited to be here. A little bit of a back story in the situation. I have a 1983 convertible 5.0 4 speed. I bought the car about 9 months ago. Drove it 50 miles and the engine became off balance and insisted on dying unless under heavy throttle. Did my first...
Top Bottom
Back
Forums
Menu