throwout bearing

So I've seen a few forums posts about this but could never come to a direct answer. Am I supposed to put any preload on the clutch when adjusting? I have read that they put preload on from the factory, but after burning through 3 throw out bearings and 2 bearing retainers I'm concerned that the...

So about a month ago, I noticed this chirping noise coming from my engine bay. At the time, it only happened right when releasing the clutch pedal and accelerating in gear, didn’t matter which gear, and sometimes it would happen when revving I’m neutral, without touching the clutch pedal. And it...

I have a 2003 Mustang 3.8L V6 that does a really loud squeal when the clutch is pushed in, however when the clutch is all the way out it doesn't make any noise. As well it only happens when I'm in lower gears like 1 or 2 and it never happens when I'm in the higher gears. The car only has 69k...

Last winter I rebuilt my t5. In addition to the transmission i replaced the clutch with a luk and had the flywheel resurfaced. I also replaced the bearing retainer with a steel one and did the input shaft. Before the rebuild the clutch was fine, if a little stiff. However since the rebuild i...

2003 Mustang Gt, 44k original miles and has been taken care of not ragged. It is modded with all the typical bolt ons and also has a procharger kit, long tubes etc. NO ISSUES PREVIOUSLY. So i was driving home and had a rod start knocking. so after i got the bad new i ordered a remanufactured...