03/04 -> 96 Tranny Swap

Malevolyn

New Member

Dec 7, 2005

18

0

0

Lakeland, FL

Dec 8, 2005

#1

• Dec 8, 2005

• #1

03/04 -> 96 Tranny Swap / Broken Shifter?

Does anyone know if the 03/04 Cobra T-56 will fit in my 96 Cobra?

Also, my shifter leans towards the driver's side (1st looks too far left, seen in this picture), is this normal? All my friends have aftermarket shifters so I really don't know.

(Sorry this is the wrong section. My mistake.)

 

M

MTShambles

New Member

Jul 8, 2005

16

0

0

Dec 8, 2005

#2

• Dec 8, 2005

• #2

I cant tell from the picture (its not letting me see it).

As far as the tranny swap goes, yes you can fit a T-56 in a 96 cobra, but its going to take some work. I would go with a TKO 500/600 instead, personally. When I was contemplating a tranny swap I was going to go with that tranny since the T-56 is VERY $$. Not to mention its a heavier tranny and will make you end up losing time on the track.

 

Malevolyn

New Member

Dec 7, 2005

18

0

0

Lakeland, FL

Dec 8, 2005

#3

• Dec 8, 2005

• #3

Oh, sorry about the picture. Try it again. Here's a much bigger version in case you want it. The angle isn't great for seeing the lean in the shifter, but it does seem like it leans a bit too far left. I can get a top down picture if you like.

 

M

MTShambles

New Member

Jul 8, 2005

16

0

0

Dec 9, 2005

#4

• Dec 9, 2005

• #4

It looks like you have an aftermarket shifter handle at least set to the left side. My shifter is like that as well.

 

Malevolyn

New Member

Dec 7, 2005

18

0

0

Lakeland, FL

Dec 9, 2005

#5

• Dec 9, 2005

• #5

Makes sense, I suppose. The guy I bought it from didn't say anything about it, so I wasn't sure. I like the lean, though. Less reaching.

 

silentbullitt

New Member

Apr 17, 2005

63

0

0

san antonio

Dec 11, 2005

#6

• Dec 11, 2005

• #6

The t56 will fit in your '96 Cobra/ That's what I had on my cobra before I sold her. You will need 6spd shifter, driveshaft to a 03/04 cobra and the tranny. Make sure you get a speedo cal. I gots mine from Dallas Mustangs and make sure to specify T56 tranny for the speedo cal. And also 3:73 work great with the T56. 3rd and 4th gear were real pulling gears and even 5th pulled some too.

 

98stangalang4v

New Member

Mar 27, 2007

6

0

0

south texas

Oct 2, 2007

#7

• Oct 2, 2007

• #7

silentbulllit - do you happen to have the part # for this speedo calibrator? i just swapped the 04 cobra t56 into my 98 cobra and the speed sensors are vastly different. i have talked to some mustang tuning shops, some say it can be calibrated with a tune and others say it wont.... im stuck without a speedo and cruise control until i figure this out...

and malevolyn - the t-56 in my 98 is amazing! it pulls pretty hard even through sixth gear. i have 4.30's an aluminum flywheel, and aluminum driveshaft though... definitlely the way to go! and with 4.30's it runs about 2300 in 6th, so its got crazy torquiness down bottom and still cruises great on the highway...