Of course the rotor will wobble with out the wheel on.i am at wits end with this.. i have a drivers side rear wheel that dubs going down the road. when i jack both wheels off the ground and put in gear the drivers side wheel wobbles in an out.. so i pulled the tire off and the rotor wobbles.. so i pulled the rotor and caliper off and my spindle spins straight as an arrow.. so is this just a caliper and rotor issue or could it be a bearing and axle?? or? thanks for any feedback!!
Good point,Of course the rotor will wobble with out the wheel on.
There is nothing to hold the rotor tight to the axle flange so it will wobble as the brake pads and caliper do not keep the rotor true to the axle flange.
You could put on a few lug nuts and tighten the rotor to the flange and try again.
My bet is a bent wheel.
I will admit, I had no idea what you meant when you said "the wheel dubs going down the road"
I had to read the rest of the post to see what you were getting at.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?