Well where do I start! This car has been a 10 yr dream of mine and I finally found the right car at the right price. However the engine has a knock which I'm not worried about I will pull the oil pan and check for play in the rods! I worry more about what the hell I'm going to do with the motor! I will be removing it in the coming weeks but I don't know what to go with? First off I will tell you what is on the motor when I purchased it then I will go into detail of my plans. The car has brand new interior plus alot of upgrades.
Current motor!
Stock 302
GT40 Aluminum heads
GT40 upper and lower intake
K&N Filter
E303 Cam
BBK headers
H-Pipe w/cats
Flow masters
3.55 gears
Center force clutch
MSD ignition
Option A
Hone the cylinders if possible, new rings and possibly new crank shaft since it knocks I hope for only a polish. I have heard not to turn them just buy a good one and have it pollished. New Rings, and bolt her back togeather!
Option B
Bore the cylinders and put a stroker kit in my reasearch tells me to go with a 331 since I want to drive her and it has to pass CA smog! I would go the extra mile with forged internals.
At the same time I will rebuild the T5 tranny just to be safe! I want a reliable build. The car has been sitting for 3 years and I'm not sure what else is going to pop up so I figure around 1500 for the motor and thats if I spend the money on the stroker kit. The best machine shop in town want 500 to prep the block other want 225. I would rather spend the extra money and get a block back that has been throughly gone through! Whats everyones take on this! Reliablility and power!! That is CA smog legal!
Current motor!
Stock 302
GT40 Aluminum heads
GT40 upper and lower intake
K&N Filter
E303 Cam
BBK headers
H-Pipe w/cats
Flow masters
3.55 gears
Center force clutch
MSD ignition
Option A
Hone the cylinders if possible, new rings and possibly new crank shaft since it knocks I hope for only a polish. I have heard not to turn them just buy a good one and have it pollished. New Rings, and bolt her back togeather!
Option B
Bore the cylinders and put a stroker kit in my reasearch tells me to go with a 331 since I want to drive her and it has to pass CA smog! I would go the extra mile with forged internals.
At the same time I will rebuild the T5 tranny just to be safe! I want a reliable build. The car has been sitting for 3 years and I'm not sure what else is going to pop up so I figure around 1500 for the motor and thats if I spend the money on the stroker kit. The best machine shop in town want 500 to prep the block other want 225. I would rather spend the extra money and get a block back that has been throughly gone through! Whats everyones take on this! Reliablility and power!! That is CA smog legal!