- Jul 30, 2006
- 0
- 0
- 0
92' LX 2.3L project car
The camshaft was locked up on the original motor, so we replaced the entire head. We had it all hooked up n' ready to go fired it up and it ran terribly, we drove it around the yard for a while then parked it to see what was wrong. A few days later we started it back up again and still was running horribly, so we checked the plugs and anything electrical that could be a problem. With nothing found we tried to start it again and it would turn over but would not start. After a few hours we found that the Harmonic Balancer was all bent up and the magnet in the Crankshaft sensor was knocked out.
Well here is where the problem comes in, we just bought a new Harmonic Balancer and Crankshaft sensor (set me back a lot of $$) and there is no spark in the coil packs or the plug wires. We have a Chilton's book looking up electrical diagrams but cannot pinpoint what could be causing them to not be getting any spark. Any help will be appreciated.
The camshaft was locked up on the original motor, so we replaced the entire head. We had it all hooked up n' ready to go fired it up and it ran terribly, we drove it around the yard for a while then parked it to see what was wrong. A few days later we started it back up again and still was running horribly, so we checked the plugs and anything electrical that could be a problem. With nothing found we tried to start it again and it would turn over but would not start. After a few hours we found that the Harmonic Balancer was all bent up and the magnet in the Crankshaft sensor was knocked out.
Well here is where the problem comes in, we just bought a new Harmonic Balancer and Crankshaft sensor (set me back a lot of $$) and there is no spark in the coil packs or the plug wires. We have a Chilton's book looking up electrical diagrams but cannot pinpoint what could be causing them to not be getting any spark. Any help will be appreciated.