I recently installed new power door lock actuators and was disappointed to find they did not actuate! I printed off a wiring diagram and determined that there are two broken wires (Pink/Light Green and Pink/Black). I figured they would be broken in the door hinge area so I proceeded to try to get a look.
I managed to peel back about 1" of the electrical tape and out of dumb luck found one of the breaks. I wasn't able to see the other one but there is a lot of wire that I can't see. Are there any tricks to getting into this wire loom to get more access to do the repairs or am I destined to struggle with the rubber boot while simultaneously trying to expose and solder the wire?
I guess the other option is to run a pair of new wires through the hole. Where do they pop out under the dash?
I managed to peel back about 1" of the electrical tape and out of dumb luck found one of the breaks. I wasn't able to see the other one but there is a lot of wire that I can't see. Are there any tricks to getting into this wire loom to get more access to do the repairs or am I destined to struggle with the rubber boot while simultaneously trying to expose and solder the wire?
I guess the other option is to run a pair of new wires through the hole. Where do they pop out under the dash?