2001 BULLITT

[IJUSTWON]

What are STOCK dyno Numbers (fwhp and rwhp) for a 2001 Mustang BULLITT??

 

[40th GT]

I know it's rated 265 at the flywheel so take away 15% and you get 225.25.

 

[IJUSTWON]

Only thing is i've read on the IMBOC site that BULLITT's net around 235-241 rwhp Stock?? Just trying to get different perspectives??

 

[IJUSTWON]

Also on some mustang sites say that Ford Underrated the factory HP ratings on the BULLITT and possibly could be putting out 275 instead of 265?

 

[IJUSTWON]

?

 

[COBRA90GT]

Also on some mustang sites say that Ford Underrated the factory HP ratings on the BULLITT and possibly could be putting out 275 instead of 265?

Sorry, realized you were probably talking about flywheel horsepower ratings (where I was looking at RWHP/dyno numbers), but the info below is still useful...blah. LOL

You have to take some of the information out there on the varous message boards with a huge grain of salt because some people don't have their facts straight.


275 RWHP SAE on a completely stock Bullitt? That's 4v territory, no way...however, if it's modded, you can definately get there, check out the following thread:

http://www.imboc.com/phpBB/viewtopic.php?topic=27769&forum=18&22

Here's another example of a basically stock Bullitt (just a K&N air filter) SAE dyno run, "236.7 SAE corrected hp and 273.0 torque":

http://www.imboc.com/phpBB/viewtopic.php?topic=4612&forum=18&2


I would continue to get information from the Bullitt owner's forum at IMBOC, register on their board, ask questions, run a search, etc - that's your best source to get Bullitt-specific information IMHO:

http://www.imboc.com/phpBB/

Make sure you visit their "dyno forum" as well & skim through all the different dyno sheets that owners have posted:

http://www.imboc.com/phpBB/viewforum.php?forum=18&2412


Hope that helped!

 

[IJUSTWON]

I'm thinking about a 5.1 Stroker kit (forged internals), borin the block .020 over, bbk headers, bbk underdrive pulleys, o/r x pipe, american thunder catback, and densecharger, what kinda HP ratings could i expect to reach with this setup??

 

[Pitch Black]

BULLITTS typically dyno around 240rwhp/280rwtq stock. As someone mentioned, check out www.imboc.com

 

[IJUSTWON]

?

 

[snkchmr]

my old one put 240 flat to the rear

 

[Stus99GT]

I had mine dynoed last week w/ mods in sig. My car had just been driven 2 hours to get to the dyno place, so that explains my lower numbers that usual, but I still pulled off 242hp 275 torque.

 

[IJUSTWON]

With the Stroker kit CHP said i would gain about 35hp, So i should put down with my mods around 260-265RWHP??

 

[IJUSTWON]

?

 

[FST BLK Pony]

mine put down 234 rwhp the other day (as it came from the factory, and 49k miles)

figuring 15% drivetrain loss that is 275 at the crank

but thats all an estimate

 

[IJUSTWON]

So despite the Specs (265HP) for a stock BULLITT it's underrated and should be 275?