GUYS I NEED HELP!!!
I am about to tackle the project of upgrading my shaker system in the 'Stang. My research shows that there are a few road blocks to go around and I am wondering if any one can help me figure this out or if some one has dealt with it already.
I am upgrading the entire front end. JBL GX628c 6.5" woofer components with 1" tweets. As well as JBL GX328 3.5" MID RANGE I am also putting the 6.5" in the rear with the tweets.
I have the premium ecoboost which has the very under-powered shaker system in it with no subwoofer.
I have ideas about what to do for the sub in the trunk.
My problem is that i don't want to change the factory head unit yet because its 500 just for the bezzel.
this means i have the harness going from the head unit to the shaker amp and then wiring going from the amp to the speakers.
I keep hearing of the Carav 12-240 harness but am not understanding how this plays into the system and me adding the DSP after the amp so i dont loose the noise cancellation wiring from the head unit to the shaker amp, however i don't know which harness on the shaker amp to tap into to go to the speakers.
Any help with this issue will be greatly appreciated.
I am about to tackle the project of upgrading my shaker system in the 'Stang. My research shows that there are a few road blocks to go around and I am wondering if any one can help me figure this out or if some one has dealt with it already.
I am upgrading the entire front end. JBL GX628c 6.5" woofer components with 1" tweets. As well as JBL GX328 3.5" MID RANGE I am also putting the 6.5" in the rear with the tweets.
I have the premium ecoboost which has the very under-powered shaker system in it with no subwoofer.
I have ideas about what to do for the sub in the trunk.
My problem is that i don't want to change the factory head unit yet because its 500 just for the bezzel.
this means i have the harness going from the head unit to the shaker amp and then wiring going from the amp to the speakers.
I keep hearing of the Carav 12-240 harness but am not understanding how this plays into the system and me adding the DSP after the amp so i dont loose the noise cancellation wiring from the head unit to the shaker amp, however i don't know which harness on the shaker amp to tap into to go to the speakers.
Any help with this issue will be greatly appreciated.