I did a 3G conversion a few years back but I don't remember it all. Also, this isn't in a Fox body. The motor is a '93 Mustang 5.0 swapped into a '54 Ford Customline, ECU/fuel injection and all. Alt is a PA Performance 130a 3G.
On the regulator plug.........
1) The YEL/WHT wire. What is it's purpose? Is that the excite wire?
2) The LT GRN/RD wire. I won't be running an idiot light. The only elec gauge will be a volts gauge. What do I do with that wire?
Any help is greatly appreciated!
On the regulator plug.........
1) The YEL/WHT wire. What is it's purpose? Is that the excite wire?
2) The LT GRN/RD wire. I won't be running an idiot light. The only elec gauge will be a volts gauge. What do I do with that wire?
Any help is greatly appreciated!
1) Connect through 14 AWG fuse link to Battery + at starter relay.
2) Connect through 500 ohm 1/4W resistor to ignition Run.
2) Connect through 500 ohm 1/4W resistor to ignition Run.