31 Spline Auburn Pro Any Good?

[onefstsnake]

Since I snapped an axle and my Tloc has seen better days I went ahead and ordered a few things.

Moser 31 spline axles
Bearings

And a buddy of mine sold me an almost new (500 miles) Auburn Pro Locker for $200.

Im only putting down 220hp and 285tq to the wheels. And I do run Mickey Thompson ET Radials.

Will this combo hold up to hard launches?

 

[the98stang]

sounds like a good combo to me. 200 bux is pretty cheap for a diff

 

[El_CUCUY]

Its a good piece but if you plan on running more power it won't hold that long...

I my self have an eaton posi with 31 spline moser axles and i have wet to feel her slip

but 200 bux is a hell of a deal compared to what i payed....
if it's new and you no it is the hell with it buy it..

 

[ALMOSTFINISHED]

I have the Auburn Pro Locker Diff and have no complaints from it whatsoever. Its one of there top differentials-holds lots-o-power.

Nick

 

[speadfreak]

I had a pro auburn with 31spline strange axles. I beat the heck out of it for years with MANY trips down the 1320. Only complaint was that when turning sharp at low speeds you could almost feel it try to hop a little bit.....but that's just par for the course with that kind of posi unit. There are alot of guys that are running three times the power that you have and use that same diff. reliably. Lots of room to grow.

 

[onefstsnake]

Im pretty sure it has an adjustable pre-load for the diff action.
It still has all the paint markings on it and everything.


My stang is my daily driver so I hope its nice on the street.


Should I install a rear end girdle? And If so, will it clear the stock sway bar?

Thanks everyone.