351 efi distibutor?

Status
Not open for further replies.
no problem sir. I was running holley systemax II heads on my 351w and i found out that 165cc intake runners compared to the 210cc intake runners on the vic jrs make a heck of a big deal. Don't buy small heads for a 351w. now i have a set of holley heads just waiting to be installed on my F-150.
 
you want some end play so the thrust washer will get lubricated. If your oil pump driveshaft is too long it will push that lobe above the gear up into the body of the distributor when you tighten down the distributor retaining bolt. No space means no lube no lube means no worky for long. It completely locked up the shaft. I look at it this way... now I have replacement parts for my new distributor. Yeah that is the last $320 i will give to MSD :)
 
well, check things out. If the shaft is seated completely down and the housing isn't seated on the engine block, you need to trim it. Conversely if the housing is completely flush with the block and there is no up and down play in the shaft, you need to trim it. If it needs trimmed, you just hit it with the grinder and re-install and re-check I think mine was about 1/8th that I had to trim from my milodon pump shaft. Just look at the uninstalled distributor and that lobe between the body and the gear and note the distance/amount of play between the lobe and distributor body. You will need that much play in the distributor shaft when installed as well to allow for proper oiling.
 
I think there must be a difference in the actual body of the two distributors. I believe the 351w have a longer body because of cleaence issues with the intake. The shaft part of the dizzy is the same length from where it mounts onto the block and down to the oil pump but above that i believe the 351w dizzy is about .83 of an inchtaller then the 302 dizzy.
 
BK-
I finally made the long trek to the garage and looked at all 3 of my distributors.
I have the original from my 302, one from a Bronco 351w donor motor, and the 351w dist I had been running in my 408w.

I couldn't tell which was the 302 and which was from the Bronco 351w. They were the same length, both above and below the mounting surface. (I am sure it won't be the last time I am wrong :nonono: )

The dist I had in the 408w however, used to be longer. I had to trim the length by about .250" IIRC.
It seems the aftermarket pump shafts don't allow the dist to fully seat without trimming.
(All three of the distrubutors I have mentioned would have been the same length, from the factory)

I will modify my 351w article tonight to reflect this.
(with as often as I post that thing, I am a little disappointed this error hasn't been caught before :eek: )

thanks for your perseverance.
Keep us posted on your progress :nice:

jason
 
Status
Not open for further replies.