351w Crankshaft Measurements?

Mustang78 · May 4, 2007

I finally got a good dial caliper, the main journals on the 351w measure out to 2.990", and the rods are 2.290, does anyone know stock? i tried a google search but no luck, i'm off to the O.R. to get my stupid pinky finger operated on so i wont be able to check this for a while(broke it about a month ago, my hand got smashed between a tree and the tractor..)Thanks

~Mark~

BK_CAULEY · May 4, 2007

MEASUREMENTS

i just measured a stock one and i got these #'s
mains -2.98937 and rods- 2.300394

vristang · May 4, 2007

BK_CAULEY said:
i just measured a stock one and i got these #'s
mains -2.98937 and rods- 2.300394

5-6 places
Holy Crap that's alot of sig. digits

What did you use to measure that out? Did it come from NASA?

jason

Mustang78 · May 4, 2007

i didnt post it earlier but i found a fe old rod beareings and they were .020" under, bu i couldent find manin bearings..sometimes even a stock crank can be machined down what looks like .010" in your case. Thanks for the info but does anyone have the measurements from a book?

~Mark~

Mustang78 · May 4, 2007

BK_CAULEY- do you have the bearings that came off that crank?? look on the back if you do and plz post up what the sizes are, thanks and soryr for3 the bad ytping i have a cast on my left hand i just got back from surgery

~Mark~

Mustang78 · May 5, 2007

TTT does anyone know a website that might have the measurements like this for a 351w??

Mark

Mustang78 · May 6, 2007

351w Crankshaft Measurements?

Mustang78

New Member

BK_CAULEY

it's built for speed not longevity, woman

vristang

Mustang78

New Member

Mustang78

New Member

Mustang78

New Member

Mustang78

New Member

Similar threads

351w Crankshaft Measurements?

Mustang78

New Member

BK_CAULEY

it's built for speed not longevity, woman

vristang

Mustang78

New Member

Mustang78

New Member

Mustang78

New Member

Mustang78

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency