4.6 carb intake

[forpit2000gt]

I don't think I can build one as cheap as I can purchase. I wont say I would never modify, but They have done most of the work already. I do have someone that can weld aluminum. We already talked about building one. I could cut up an old Rousch or Edelbrock intake from windsor engine to do this, I just don't think that is the right way to go now.

 

[tjm73]

The simplest solution looks like that Reichard Racing intake with a custom carb mounting plate to replace the "elbow" top plate. Plug the injector holes (or turn them into direct port NOS locations) and give it a go.

http://www.reichardracing.com/46liter_intake.php

 

[forpit2000gt]

with what I have seen nitous setups do to aluminum intakes in a fogger setup, I deff. don't want a plastic intake. If I was NA, that may be OK.I also dont thing the plastic intake will support the power level I am talking about.

 

[tjm73]

with what I have seen nitous setups do to aluminum intakes in a fogger setup, I deff. don't want a plastic intake. If I was NA, that may be OK.I also dont thing the plastic intake will support the power level I am talking about.

Yeah fogger that's word I was looking for but couldn't think of.