ite, this weekend i will be picking up my 4v 2000 continental engine, i know about the block and all that good stuff.. however, do these have the 99-01 cobra 200 degree intake cams? or the 18x? newer mach/marauder/aviator/cobra/lincoln tank cams?
it matters because, if it has the 99-01 cams i will run those..
also any negative side effects to milling the heads .030?
basically it will be a bastard 4v build with an iron block, and cast crank, with the C heads and a mach intake.. should be funner than a pi swap 2v lol
it matters because, if it has the 99-01 cams i will run those..
also any negative side effects to milling the heads .030?
basically it will be a bastard 4v build with an iron block, and cast crank, with the C heads and a mach intake.. should be funner than a pi swap 2v lol