i was thinking about building a stroker engine on an engine stand then dropping it in when i was done with the build. but i wanted to se what kind of power it would be making... and if its worth the extra money.
i was going to get a used block out of a wrecked mustang... clean it up, get it bored out and sleeved to .02 over. get the 302 crank, some forged H beams, and pistons to get around 11:1 CR. would this get enough power for the money? or would i be better off just getting a supercharger and calling it quits.
I would be adding long tubes, H pipe, and magnaflows later on, and prolly a new intake.... depending on what it out there at that time, if i chose to stay NA...
what do you guys think of this situation.
Torinalth
i was going to get a used block out of a wrecked mustang... clean it up, get it bored out and sleeved to .02 over. get the 302 crank, some forged H beams, and pistons to get around 11:1 CR. would this get enough power for the money? or would i be better off just getting a supercharger and calling it quits.
I would be adding long tubes, H pipe, and magnaflows later on, and prolly a new intake.... depending on what it out there at that time, if i chose to stay NA...
what do you guys think of this situation.
Torinalth