I need to have my driveshaft cut and have a different yoke welded on the axle end so I can use a large u-joint to match the 9" yoke (I tried to find a adapter u-joint w/ no luck and have given up on this).
I need to know how much clearance is needed from the end of the C4 transmission tail section to the ears of the driveshaft yoke so they do not come in contact during suspension travel. What is too much? I was thinking about 1.5". I have read I need .75"-1" clearance, but is what I read the same clearnace that I'm questioning?
From my measurements, I dont think I even need to cut any lenght out of the current driveshaft, but some day (years from now) I want to upgrade to a T5. Is the T5 longer and should I maybe cut a little shorter than needed now to advoid a driveshaft mod later?
Thank you!
I need to know how much clearance is needed from the end of the C4 transmission tail section to the ears of the driveshaft yoke so they do not come in contact during suspension travel. What is too much? I was thinking about 1.5". I have read I need .75"-1" clearance, but is what I read the same clearnace that I'm questioning?
From my measurements, I dont think I even need to cut any lenght out of the current driveshaft, but some day (years from now) I want to upgrade to a T5. Is the T5 longer and should I maybe cut a little shorter than needed now to advoid a driveshaft mod later?
Thank you!