Advanced Timing

May 20, 2005
1,156
2
48
Arkansas
I have the Steeda Timing Adjuster on my car and it's set forward 4 degrees up to 14. I was wondering if anyone could tell me if going to 15 would be worse on my motor or would help me out or not make a difference or what?.. Thanks in advance for your help
 
i know this is gonna sound stupid.. but how will i know it if it starts with the detonation? :shrug: dumb question, but i'm just not used to that stuff.. and i run 93 octane gas from a Shell gas station, if that helps with any info..
 
Detonation is the motor killer. If you hear it you should take corrective action asap. It can shatter pistons and other really bad things. I am not sure what technically is going on under detonation but a search should give you some answers...
 
jasonh_86 said:
I know.. the previous owner made sure i put 91 or higher in it unless i were to back the timing down.. but what will detonation do to my motor if it happens one day?


Some light detonation every once in a while can happen and it won't won't do and majordamage to the engine, it happens from time to time if you get bad gas or something. It can also happen when the air temp is very high and the air is thin. But a lot of it will kill the engine. You stand a good chance of burning a piston.

But as faras I'm concerned, any pinging is very bad. I have my T/A set at 15 and I make sure to run nothing but 93 oct in it.
 
alright.. the guy told me that Steeda told him 15 is the highest you should turn it on the stock internals and everything.. he said 15 was basically the breaking point, and 16 was too far.. so that's why he always kept it at 14.. but i'm not sure if i wanna turn it up just one more degree with the risks of messing something up, i dont figure it'll give me any gains worth risking stuff like that
 
Kilgore Trout said:
Detonation is the motor killer. If you hear it you should take corrective action asap. It can shatter pistons and other really bad things. I am not sure what technically is going on under detonation but a search should give you some answers...

Detonation occurs when the air/fuel mixture fully burns BEFORE the piston gets to TDC. Basically, the explosion is already pushing down on the piston while it is still coming up. The engine doesn't like this. The ping noise is the piston banging around inside the cylinder.
 
to add to AdRock, parts can be broken because there are two forces taking place in the engine, 1. the A/F mix is exploding prematurly and pushing down on the piston which itself is being pushed up by the crank via the connecting rod and piston wrist pin