Air bag light flashes

[larbec7]

I have a 1994 Stang 5.0 that i hust bought my son and the airbag light stays on. I checked a chart for a 93 model and it is giving a flash code of a 52. I will assume that the 93 is the same as a 94 unless someone corrects me.

How do I repair this and where is it?

52 | Backup power supply fault | R |


Thanks

 

[chuck943]

Gray connector behind glove box on left side with 2 wires in connector T/R and BLK.
Cycle the ignition switch to OFF and then to RUN.
Observe air bag indicator prove-out (six ± two seconds) followed by diagnostic trouble code (52-85) flashing completely one time.
Locate the Diagnostic "Trouble Code Clear" Connector located underneath the glove compartment (06010) containing Circuits 631 (T/R) and 57 (BK).
Use a jumper wire to short Circuit 631 (T/R) to Circuit 57 (BK) or to another good ground. This short must be made after the diagnostic trouble code flashes completely one time, but before the warning light stays on continuously.
Hold short until air bag diagnostic monitor tone sounds (approximately five seconds).
Release short on Circuit 631 (T/R) to Circuit 57 (BK). This short must be released within 25 seconds after the diagnostic monitor tone sounds.
Diagnostic trouble code is now cleared from NVRAM. Next highest priority diagnostic trouble code stored in NVRAM (if one exists) will begin flashing

 

[larbec7]

Thanks

I will try this tomorrow, too late now

Thanks a bunch!!!

 

[BlownFiveLiter]

This site will help with your airbag codes.

 

[larbec7]

What is T/R ? I know BK = Black right??? Are these labeled like this??

If I do this, will my airbag come flying out?

Thanks for the help

 

[chuck943]

Tan/Red .
Code 52 is from low voltage to module. Doing the process I described is to clear that code. If nothing else is wrong then you are done if something is wrong then it should flash another code.

 

[phillipstheman1]

whos doesn't every mustang ive been in does seems like

 

[larbec7]

I took the glove box out and I can see all the wires and connectors. There is not a two wire connector. On the left is a four wire with (Red, Blue, Black and a whiteish color looks ) and the only grey connector has about 6 wires that llok to be number 24 awg.

HELP!

 

[chuck943]

sometimes its taped up in the harness so its hard to see. but its in that area,look from center brace over to left side of glove box

 

[94v6GT]

you dont have to take the glove box out. mine was taped to other wires UNDER the glove box.