• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

All kinds of squeaking from wheel area

  • Thread starter Thread starter techium
  • Start date Start date Jun 2, 2010

techium

New Member
Dec 8, 2005
20
0
0
Jersey
Jun 2, 2010
#1
  • Jun 2, 2010
  • #1
Basically my car has this loud squeak sound when I turn the wheel, and whenever i am going over a speed bump of some sort. I think at least for the speed bump part it must be the shock as it squeaks when it compresses.

Also, if I have the break pedal pressed down and I turn my steering wheel, the pedal pushes back ever so slightly. Is this weird or have I just not noticed it before?

Either way, I want to get rid of my damn car.
 

sneaky98gt

10 Year Member
Apr 23, 2008
2,387
144
114
NC State University
Jun 2, 2010
#2
  • Jun 2, 2010
  • #2
I don't know if mine squeaking is the same as yours, but lately, mine has gotten horrible. I mean, driving 60 mph down a newly paved road and it is squeaking; sitting still and moving in the car a bit and it is squeaking; getting in and out of the car, squeaking; turning the wheel, squeaking. It has always done it a little bit when going over bumps and such, but never this bad. And I'm getting a little tired of it as well. It's no fun getting stared at by strangers not because your car looks good, but because it is making all kinds of funky noises.

Oh well. Gives me an excuse to get new springs/shocks/struts and lower the car.
 

32ValveRom

Member
Feb 15, 2009
328
0
17
Fl
Jun 2, 2010
#3
  • Jun 2, 2010
  • #3
I don't know if my squeaking is the same as either of yours but I used to have a 98 vert that would squeak over speed bumps and even if I parked the car and just shook it from the outside you could here a little squeaking. Sounds like a hamster's exercise wheel and gets on my nerves especially with Honda loving family who thinks American cars are cheap pos
 

N8Dogg98

15 Year Member
Apr 4, 2005
3,872
238
184
MN
Jun 3, 2010
#4
  • Jun 3, 2010
  • #4
It's really difficult to diagnose a noise over the internet, but I'll do my best. Get your car up in on jack stands and visually inspect the suspension. Grab the tie rods and try moving them back and forth, grab the wheel on each side and try moving it side to side and back and forth, etc.... until you are able to identify where the noise is coming from.

I also had a terrible squeak from my front suspension a couple of years ago. Every time I turned the wheel it would squeak and it squeaked over bumps, etc... When I jacked up my car, I could replicate the noise by grabbing and trying to move the right tie rod end. I replaced both tie rod ends and the noise hasn't been back yet.

O'Reilly sells replacement tie rod ends for cheap. Also, they are made by Moog and have grease fittings (pretty nice pieces if you ask me).
 

techium

New Member
Dec 8, 2005
20
0
0
Jersey
Jun 3, 2010
#5
  • Jun 3, 2010
  • #5
thanks guys, i'll see if i can diagnose it later. **** is pissing me off!
 

N8Dogg98

15 Year Member
Apr 4, 2005
3,872
238
184
MN
Jun 4, 2010
#6
  • Jun 4, 2010
  • #6
Glad to help, let us know what you find out.
 

trombonedemon

Well-Known Member
Jun 25, 2009
1,962
39
59
U.S.A, U.S.A., U.S.A.!
Jun 4, 2010
#7
  • Jun 4, 2010
  • #7
My car started to squeak when the rear end's bearing started started to leak, when the bearings gave so did the axles seal, the rear end fluid got on my breaks and rotors, glazed both. Didn't help my brake pads were ceramic slash metal. After calling the insurance rep boss they finally gave me new seals and bearings, and I made them change the pinion seal cause the mechanics were irritable douche's. Anyway, I also made them give me new break pads on the side that were squealing. Squeal gone, but, the the rotors are ruined still. So every time I go over a bump the rotor touches the brake pad and squeaks. This is after I changed all the shocks including the Quads. Dealerships lick ballz. Insurance reps w/dealerships lick Brown eye, bitch tried to save every penny she could. I think would have assaulted that dike if the bearings would have gave and hurt me and my wife. End of Rant.
 
M

mr-mike

New Member
Jul 9, 2006
122
1
0
Jun 4, 2010
#8
  • Jun 4, 2010
  • #8
get a needle injector & put some grease in the non geasable ball joints let the wheels hang inject the gease into the rubber gently then turn the wheel from side to side ...... if it goes away then that was problem its common on Mustangs
 
M

MystangGT02

New Member
Jun 8, 2010
1
0
0
Jun 8, 2010
#9
  • Jun 8, 2010
  • #9
I have a similar squeak and something I noticed that wasn't mentioned was having to replace the throw out bearing. If this is loose or worn it can create a similar squeak. If you're in lower gears it's usually worse, especially when gently pushing or releasing from the clutch. I was told that my transmission would have to be taken out to replace this (bad news). One identifier that seems to be different then some issues I'm reading here are that mine occurred while idling.
 

N8Dogg98

15 Year Member
Apr 4, 2005
3,872
238
184
MN
Jun 9, 2010
#10
  • Jun 9, 2010
  • #10
MystangGT02 said:
I have a similar squeak and something I noticed that wasn't mentioned was having to replace the throw out bearing. If this is loose or worn it can create a similar squeak. If you're in lower gears it's usually worse, especially when gently pushing or releasing from the clutch. I was told that my transmission would have to be taken out to replace this (bad news). One identifier that seems to be different then some issues I'm reading here are that mine occurred while idling.
Click to expand...

OP said the squeaking happens when he turns the steering wheel and when going over speed bumps. I doubt it has anything to do with the TOB.
 
B

BetterBaGT

New Member
Jun 8, 2010
49
0
0
Phoenix, AZ (unfortunately)
Jun 9, 2010
#11
  • Jun 9, 2010
  • #11
N8Dogg98 said:
OP said the squeaking happens when he turns the steering wheel and when going over speed bumps. I doubt it has anything to do with the TOB.
Click to expand...

You're probably right...I doubt it too. But if it was ALSO squeaking at low speeds (without turning the wheel), it could be the issue. If not, I completely agree that it's out of the question.
 

N8Dogg98

15 Year Member
Apr 4, 2005
3,872
238
184
MN
Jun 9, 2010
#12
  • Jun 9, 2010
  • #12
BetterBaGT said:
You're probably right...I doubt it too. But if it was ALSO squeaking at low speeds (without turning the wheel), it could be the issue. If not, I completely agree that it's out of the question.
Click to expand...

If the squeak makes the same sound when going over bumps as it does when turning the wheel it has to be suspension related. A TOB would not squeak when turning the wheel.
 

StangSims39

Member
Apr 17, 2010
164
0
17
Farmingdale, NY
Jun 10, 2010
#13
  • Jun 10, 2010
  • #13
Mine started to squeak too, first it was a grinding noise when i would go fwd with the wheel cut all the way to the left or right, my mechanic tightened something up and it was gone, but then it started to squeak only when the wheel was turning to the right, i have to take it back he said the suspension was fine, and the ball joint looked ok, he thinks it might be the steering column, hes gonna take it apart and lube everything up to see if it goes away :\
 

BlkThndr66

New Member
Apr 8, 2004
67
0
0
McHenry,IL; Joliet,IL; & Dekalb,IL (NIU)
Jul 12, 2010
#14
  • Jul 12, 2010
  • #14
My 96 Cobra does the exact same thing. When finished braking, coming to a stop; the weight transfer at stop when the front end lifts up theres a loud squeak. Turning the wheel while stationary, or moving, same squeak. This isnt a little hampster, this is loud, and sounds horrible, like metal on metal scraping. I use silicone spray around the ball joint and it goes away after its worked in a couple hours or a day, then comes right back. Gotta change em eh? How difficult is that for the weekend mechanic like myself?
 

BlkThndr66

New Member
Apr 8, 2004
67
0
0
McHenry,IL; Joliet,IL; & Dekalb,IL (NIU)
Jul 22, 2010
#15
  • Jul 22, 2010
  • #15
seems like this topic may be dead, but I hate it when people figure out their problem and NEVER post the solution!

That squeaking... I guarantee you that it is the ball joint(s). The weight transfer up and down on the front end cause pressure and release on the ball joint, as well as while turning the wheel obviously. This squeaking and high pitched whining is most certainly from the ball joints.

I had a particular awesome day... I was pulling up to a stop sign and all of a sudden *BOOM* the whole passenger side slams down at once. I get out and what I find is truly a nightmare.

The ball joint gave out on the front passenger side. So the entire weight of the corner is sitting on the tire/rim. The fender has been horribly damaged; pushed in and up out of alignment, also denting in all around the wheel well. 2 new ball joints later; she drives excellent, but looks like a junky project car now.

A word to all of you out there with squeaky suspensions...
GET IT CHECKED OUT BEFORE YOU DESTROY YOUR FRONT CLIP!!!!
 
You must log in or register to reply here.

Similar threads

Drivetrain Rear end clunk
  • seanmahoney
  • Oct 13, 2025
  • SN95 4.6L Mustang Tech
Replies
3
Views
420
SN95 4.6L Mustang Tech Oct 13, 2025
nickyb
J
Severe shaking/vibrations in steering wheel
  • jacket999
  • May 20, 2025
  • SN95 V6 Mustang Tech
Replies
8
Views
844
SN95 V6 Mustang Tech Jun 1, 2025
NtheGAME
N
A
2001 Mustang GT, scorched metal smell and noise from trans/diff?
  • AndyE2255
  • Dec 1, 2025
  • SN95 4.6L Mustang Tech
Replies
4
Views
468
SN95 4.6L Mustang Tech Dec 28, 2025
gkomo
D
2003 Mustang Steering pulls left bad after and accident , screeching while driving help please
  • dustbustet707
  • May 9, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
6
Views
346
1996 - 2004 SN95 Mustang -General/Talk- May 13, 2025
Noobz347
B
Where to go from here on my build…
  • B0udreaux
  • Jul 14, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
206
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 18, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?