i JUST INSTALLED A ADJUSTABLE FUEL REGULATOR ON MY 89 AND AM WONDERING ABOUT THE PRESSURE VERSUS VOLUME, IF THE PRESSURE IS HIGHER SAY 41 LBS IS THAT MORE OR LESS FUEL THAN 38LB?
ok so how much pressure would 19lb inj stand? and what is the stock regulators pressure?
WHEN YOU HAVE MORE PRESSURE, YOU HAVE MORE FUEL. yOUR ALSO LIMITED TO WHAT THE INJECTORS SPEW OUT AND HOW MUCH FROM WHAT THE COMPUTER TELLS IT. can you hear me now? lol
What subject are you talkin about? Where talking fuel pressure and fuel injectors and your talkin pumps. Do u set ur fuel pressure lower at your fpr and the gauge mounted on your rail expecting more fuel pressure at your injectors? For u engines sake, i hope notWRONG.
The higher the fuel pressure, the less the volume.
A 190lph fuel pump is equivalent to 50gal/hr. Here is an example pump flow rate for a 190lph fuel pump with flow in gal/hr. As you can see, the pressure to volume is an inverse relationship.
Fuel Pressure (psi) gal/hr
0 56
10 52
20 48
30 44
40 40
50 36
60 32
70 28
80 22
90 12
WRONG.
The higher the fuel pressure, the less the volume.
A 190lph fuel pump is equivalent to 50gal/hr. Here is an example pump flow rate for a 190lph fuel pump with flow in gal/hr. As you can see, the pressure to volume is an inverse relationship.
Fuel Pressure (psi) gal/hr
0 56
10 52
20 48
30 44
40 40
50 36
60 32
70 28
80 22
90 12
I'm not really sure what you are getting at here, but I don't think this is the question the original poster was trying to ask...
When you increase the fuel pressure in the rail, then more fuel is going to flow for the same injector pulsewidth.
In other words...
More PSI = More Volume Flow
Again, I'm not sure what your getting at with the pump comments...
Maybe you can elaborate?
jason
Here is the answer to the question you were trying to ask...ok so how much pressure would 19lb inj stand? and what is the stock regulators pressure?
The answer to the question you did ask...so how much pressure would 19lb inj stand?
I get it...Fuel Pressure (psi) gal
0 56
10 52
20 48
30 44
40 40
50 36
60 32
70 28
80 22
90 12

lolThis is one of those....
"my bad" situations....
I skimmed through the original question and didn't read it through.
Sorry, I take it back!
This time....![]()

I get it...
You are talking about the relationship between pressure and volume in a sealed system...
PV=nRT (IIRC)
This is different from the effects of pressure on Volume Flow...
jason