any one with this set up?

Mods list
GT-40X303 aluminum heads
Ford Racing Performanc Parts E-cam
FRPP 1.6 roller rockers
Polished Cobra intake
Edelbrock 65mm throttle body
73 mm C&L MAF
Summit Racing cold air induction
FRPP24 lb injectors
BBK adjustable fuel pressure regulator
March underdrive pullies
3.73 rear gears

FRPP Jet-Hot coated unequal length headers
Bassani catted X-pipe
SLP Loudmouth cat-back.

***********************************

So?
 
I just rebuilt the engine last year and it's only got about 250 miles on it. Haven't gotten the car out yet, but it should have excellent compression. The cam really doesn't have much to do with compression.

I do not have roller rockers, but you may have to shim, just depends.

If I recall correctly, vacuum was around 14* hg at idle w/ the E303.
 
oh man

I just rebuilt the engine last year and it's only got about 250 miles on it. Haven't gotten the car out yet, but it should have excellent compression. The cam really doesn't have much to do with compression.

I do not have roller rockers, but you may have to shim, just depends.

If I recall correctly, vacuum was around 14* hg at idle w/ the E303.

oh ok then theres some thing wrong with mine. i have about 10 hg. and climbs up at higher rpm
 
I just rebuilt the engine last year and it's only got about 250 miles on it. Haven't gotten the car out yet, but it should have excellent compression. The cam really doesn't have much to do with compression.

I do not have roller rockers, but you may have to shim, just depends.

If I recall correctly, vacuum was around 14* hg at idle w/ the E303.

how's it run?
 
It runs pretty well. I rebuilt the engine last summer and only put about 250 miles on it before I put it up for winter, which was back in November. I'm getting it out this week. Perhaps you have a vacuum leak which is what is causing yours to have lower vacuum?

Make sure all of your vacuum lines are hooked up. If you have any vacuum lines that aren't being used, cap them off. Check for leaking gaskets. If I remember correctly, vacuum goes up to about 25 when I hit the throttle, but then quickly corrects and goes closer to 0. At WOT, vacuum is nearly zero, which is how it is supposed to be.
 
Sorry man, I was wrong. My GT w/ the similar setup to yours idles at about 650 (stock) with about 11 Hg of vacuum. Push the gas, vacuum goes down, let up a little and it jumps up over 20 and bounces a round a bit. I just got the car out yesterday and noticed that, so I thought I'd let you know.