Anyone Else Waiting?

[HGFireHazard]

I ordered my 80mm MAF from PMAS on the 18th of last month and they are STILL on back order. All I need is this stupid thing so I can start my newly S/C engine for the first time! Just wondering if anyone else is in the same boat as I am.

 

[95cobraguy]

i sent them my 80mm to be recalibrated and had new electronics put in, got it back yesterday. total turnaround time was a little over a week. i already had the meter though.

 

[final5-0]

I ordered my 80mm MAF from PMAS on the 18th of last month and they are STILL on back order. All I need is this stupid thing so I can start my newly S/C engine for the first time! Just wondering if anyone else is in the same boat as I am.

With the new charger, I'd bet you're chompin at the bit to drive it

How are you gonna tune it btw?

Grady

 

[Darek78]

i had mine orderd thru this guy's got it in 2 week period The magic mustang did not accept credit card over the phone But Larocca's did
LAROCCA'S PERFORMANCE

1600 ENGLISHTOWN RD.

OLD BRIDGE, NJ 08857

732-723-1111

Derek.N

 

[HGFireHazard]

With the new charger, I'd bet you're chompin at the bit to drive it

How are you gonna tune it btw?

Grady

I'm taking it to a dyno and having a chip burnt for it. There is a dyno in Lansing (about 25 miles away), but last I heard their dyno is down. The other place I was considering is Paul's High Performance down in Jackson, which is a bit farther. I wouldn't mind trying to learn how to use a Tweecer and such, but I don't have a laptop yet. It wouldn't really be cost effecient. I can't wait to get behind the wheel and give 'er a go! I'll be sure to post up a dyno sheet for ya too Grady when all is said and done.

 

[final5-0]

I'm taking it to a dyno and having a chip burnt for it. There is a dyno in Lansing (about 25 miles away), but last I heard their dyno is down. The other place I was considering is Paul's High Performance down in Jackson, which is a bit farther. I wouldn't mind trying to learn how to use a Tweecer and such, but I don't have a laptop yet. It wouldn't really be cost effecient. I can't wait to get behind the wheel and give 'er a go! I'll be sure to post up a dyno sheet for ya too Grady when all is said and done.

Hey thats Great

I've seen good things said about Paul's on this site.

It would be a bit more involved to use a forced combo to cut your Self Tuning teeth on

Look forward to seeing how things turn out for you

Grady