Are These Flywheels Usable Or Scrap?

Mustang5L5

That is…until I whipped out my Bissell
Mod Dude
Feb 18, 2001
43,372
18,120
224
Massachusetts
Cleaning out the junk pile. I have these two flywheels.

One i resurfaced and put on my car only to find one of the clutch bolt holes stripped.

Other is unknown condition.

I want to sell them, but if they are junk I don't want to screw someone over. Can that stripped bolt hole be retapped larger or would the balance be thrown off?

IMG_2863.webp
 
That 5.0 bell housing is worth a couple bucks...they sell around here for 50- 100 bucks.

I never toss a decent flywheel. The bolt hole could probably be tapped the same size....or they all could be tapped bigger.
 
Could helicoil the flywheel as well.

They have no use to me. The trans parts though I'll keep. I just need a new gearset and I could rebuild that t5 up. I prettt much just need all the hard gears, and to sleeve the mainshaft
 
They are just stock OEM ford wheels.

They've already been cast into the pile of steel behind my shed. Got a few rotors back there. I'll wait til I have a big enough pile and then put it on the curb and someone usually drives by and scoops that stuff up within 24 hrs.
 
I was using the rotors to hold down the tarp over my firewood pile. You'd think a 13" rotor would do a pretty good job, but the nor'easters and blizzards we get have some damn good winds.

Maybe a couple of flywheels will do the trick
 
You'd almost have to pack them in leather then sew into the tarp, just to keep it from ripping.

Remember the old oil-skin tarp that our Dads had? Try finding one now.

They were bullet proof (figuratively). Made from similar material as the external layer on a fire hose.