Autometer Air/fuel guage O2 sensor input wire??

[98blackstallion]

Anyone install one of these guages? Do you know which wire is the o2 sensor input wire that your supposed to connect the guage too? i have 2 whites, a black and a grey. THanks

 

[98blackstallion]

anyone?

 

[jstreet0204]

The black wire is the sensor wire. But it is easier to tap into the PCM harness.
Pin number 87 at PCM, red w/black stripe or Pin number 60, gray w/light blue stripe.

 

[98blackstallion]

so either one of those will work then.

 

[OUR01GT]

I hooked up to the #60 wire at the PCM.

 

[jstreet0204]

so either one of those will work then.

Yes, one is for the left, one is for the right, but I don't remember which is which. I had mine hooked up to a switch to switch between the two. It was really just a way to see if the o2's were working. The guage isn't much use for anything other than that.

 

[BennyBlown2v]

If you want wideband for cheap (yet still accurate) and wanna keep your autometer gauge, checkout the Innovate LC-1. I just picked mine up for 179.99 over at DynoTuneNitrous.com, good guys over there.