Autometer gauge's question

bigcahoona

Member
Apr 11, 2005
74
0
6
Chi Town
I just installed my oil pressure, water temp and volt gauges into the pod. I bridged the 12v wiring for the lights into one wire and added a 5 amp fuse at the end. I bridged - wiring into one and grounded. Same with ign wires, into one with a 5 amp fuse at the end, ground to ground. Sender's I know where they go. My question is where's the best place to tap into the lights and where to tap into the ign for a clean and solid hookup.
 
bigcahoona said:
I just installed my oil pressure, water temp and volt gauges into the pod. I bridged the 12v wiring for the lights into one wire and added a 5 amp fuse at the end. I bridged - wiring into one and grounded. Same with ign wires, into one with a 5 amp fuse at the end, ground to ground. Sender's I know where they go. My question is where's the best place to tap into the lights and where to tap into the ign for a clean and solid hookup.


Fuse box, you can get an electrical piece that wraps around the fuse and steals power.
 
Dimmer switch for my gauges so the lights are controlled by the riostat on the dash. My gauges are mounted under the radio so I was able to tap into the dimmer wire for the factory radio.
 
i took my dash pad off and tapped into the light power going to my heater controls. That way the lights come on when i pull on the lights and as srothfuss says it will dim like the rest of the lights in the interior.
 
If using a pillar pod, grabbing the dimmer lighting source at the headlight switch is clean. Otherwise, as mentioned, fuse 13 works well (you could tap at the back of the fusebox for a cleaner aesthetic).

Good luck.