Autometer Wiring for 68 Eleanor clone

The place you got the pod from can't help with a pinout on the connector? i assume you got the pod prebuilt? You may have to trace each wire and pull the instructions off the Autometer site to map out you own pinout diagram. If someone were to have the pinout, they will need to know who makes the inst cluster you have. You say the link "looks" like the one you have. Who is the vendor that supplied the pod?

Ohhhh...well then, you most likly have to draw a diagram and trace each wire. One wire should gang all the grounds together, one should gang all the gauge illuminatin bulbs together, one will gang all the 12v gauge feeds for the gauges that require 12v (I think all of them will) One will be a tach wire, if the speedo is electronic-one wire to the speed sensor, one to the temp sender, one to the oil press sender, one to the fuel sender, and so on. Once you have a set of Autometer instructions, you should be able to figure out your pin out.