B CAM

KEN08G37 · Feb 26, 2011

Just wondering if It would be possible to install a b-cam in a stock motor? Would i need to do anything else?

Celeb · Feb 26, 2011

KEN08G37 said:
Just wondering if It would be possible to install a b-cam in a stock motor? Would i need to do anything else?

Not really, maybe some new lifters but you probably aren't going to gain anything other than a choppy idle. Might even lose a little.

stykthyn · Feb 26, 2011

You will lose hp and driveability with an aftermarket cam on a stock set up. Invest in a better top end first. An explorer top end can be had for cheap and will give you great results.

KEN08G37 · Feb 26, 2011

What about putting a Cobra intake on a stock block?

stykthyn · Feb 26, 2011

a step in the rigt direction. The intake itself will only be good for about 15-20hp without a set of matching heads.

2000xp8 · Feb 26, 2011

I've done them both on stock engines (except the cam was similar to an e), neither one are really worth the trouble.

BYRDPE · Feb 27, 2011

go ahead and install the cobra..you will pickup ~ 15-20 ponies.

Dino Dino Bambino · Feb 27, 2011

BYRDPE said:
go ahead and install the cobra..you will pickup ~ 15-20 ponies.

On an otherwise stock (or near stock engine), a 15-20rwhp gain from installing a Cobra intake is a pipe dream. A 6-8rwhp gain is more likely.

2000xp8 · Feb 27, 2011

Bullitt95 said:
On an otherwise stock (or near stock engine), a 15-20rwhp gain from installing a Cobra intake is a pipe dream. A 6-8rwhp gain is more likely.

yup.

On the other hand a good mass air meter is worth it, takes minutes to install and you get a proven .2 in the quarter.
No you probably can't feel it, but it's there.

KEN08G37 · Feb 28, 2011

So I've decided to just do heads, cam and intake all at once. I bought a used Cobra intake today and am now looking for a set of aluminum heads. I suppose I'll need to ugrade my injectors, mass air and throttle body..etc. Any suggestions on the right brand or combination or any other misc stuff I'll need?

bgoins · Feb 28, 2011

KEN08G37 said:
So I've decided to just do heads, cam and intake all at once. I bought a used Cobra intake today and am now looking for a set of aluminum heads. I suppose I'll need to ugrade my injectors, mass air and throttle body..etc. Any suggestions on the right brand or combination or any other misc stuff I'll need?

U should do a quick search for H/C/I combinations on here and check out some of the mustang mags websites. They have done plenty of tests with dyno results of different combinations. Beware: For every person you ask you will get a different opinion.

87AODGT · Feb 28, 2011

for a cobra intake and stock bottom end I would throw some AFR 165s on it, probably not goin to really get much more with 185s with just a cobra intake.

B CAM

KEN08G37

Member

Celeb

stykthyn

I want to measure mine. It doesn't look that tall.

KEN08G37

Member

stykthyn

I want to measure mine. It doesn't look that tall.

2000xp8

BYRDPE

Dino Dino Bambino

2000xp8

KEN08G37

Member

bgoins

Member

87AODGT

Similar threads

B CAM

Member

I want to measure mine. It doesn't look that tall.

Member

I want to measure mine. It doesn't look that tall.

Member

Member

Similar threads

Privacy & Transparency

Privacy & Transparency