bad news

[50foxbody]

i started taking my interior out my 86 just to clean things up a bit. i was taking the seat belt bolt out (trying to anyways) but had a cheap set of torx bits and one broke and sliced my palm wide open so ill be out of my project for awhile ill get pics tomorrow of what i got accomplished but ill keep everything posted i think there are a few things i can still do but we will see.

quick question is there any way to restore faded panels?

 

[S&B]

you can paint them to restore but thats about it, if you have red interior you can bleed over everything to restore

 

[50foxbody]

na i have tannish beige interior but thanks though might paint them or find a donor

 

[FrankenStang]

i started taking my interior out my 86 just to clean things up a bit. i was taking the seat belt bolt out (trying to anyways) but had a cheap set of torx bits and one broke and sliced my palm wide open so ill be out of my project for awhile ill get pics tomorrow of what i got accomplished but ill keep everything posted i think there are a few things i can still do but we will see.

quick question is there any way to restore faded panels?

Pics of hand carnage ftw.

you can paint them to restore but thats about it, if you have red interior you can bleed over everything to restore

 

[50foxbody]

i would post a pic but dont want to gross any one out

 

[stykthyn]

ive only seen one beige interior. i thought it looked great!

 

[50foxbody]

yea i agree but its in ruff shape the seats are beige with red trim on the seats but of course i have that comon rip on the drivers seat

 

[5.0Droptop]

Your gonna let a little cut keep you from working on your car? I cut my thumb off, wrapped a rag around it and finished installing my engine trans and painted the car all in one night. Man up!

 

[50foxbody]

ha ha who are you trying to impress ha ha just trying to keep it clean should be good by the weekend i hope

 

[5.0Droptop]

Im just givin you a hard time. Hence the

 

[50foxbody]

yea i know the freakin wife will not let me even wash my damn truck couldnt imagine askin to work on the stang ha ha

 

[5.0Droptop]

You shouldnt have to ask. I guess we know who wears the pants over there. LOL

 

[50foxbody]

its ok i gotta do some things to get some things

 

[5.0Droptop]

mmm, things.

 

[ID89GT]

Haha wow

 

[82CapriRS]

its nearly a flesh wound lol. i cut a chunk of my pointer finger OFF, it was gone!, it took part of my nail with it lol. i rapped it with paper towels after i ran it under water and peroxide an topped it off with some electrical tape an i was good to go. turns out my emt friend said i need stitches, crazy glue worked fine, somehow my finger looks fine lol. what kinda panels?? interior im guessing?!? lol

 

[50foxbody]

yes the interior 1/4 panels

 

[Mustang5L5]

That's nothing

When i was doing my AOD to t5 swap, i was intalling the T5 alone by benchpressing it up ALONE. It slipped, i tried to catch it, and it basically fell straight down onto my finger. It was squirting blood and I did some minor tendon damage. A trip to the E-room and a few stiches later and I was under the car again with a glove putting the trans back in!!

Actually, 4 months later, i still have trouble bending the finger

 

[Shaolin Crane]

Your gonna let a little cut keep you from working on your car? I cut my thumb off, wrapped a rag around it and finished installing my engine trans and painted the car all in one night. Man up!

same here i cut my thumb off and still installed my rear axle

 

[82CapriRS]

also had crossmember with trans attached, come down an smack me in the face. to much grease, hand slipped. that hurt! but i didnt get out from underneath the car. had a huge lump on my cheekbone. hurt like hell to move my mouth for a couple days. i think cuts an bruises make me wanna finish the job an show the lil ***** whos boss lol. also what makes it so fun, always stories to tell from workin on cars.