So i'm installing my BBK Longtube headers, and i'm having an impossible time trying to reconnect the EGR tube to the driver's side header. I can get it cross threaded down quite a bit, but not all the way. Me n my friend have been workin on this problem for two hours now and have no luck. My dad thinks the nut and the fitting have different threadings, causing it not to line up. My friend thinks we may have just stripped the thread from trying too damn much, which he suggested we try having it re-threaded, but don't know how we would do that. I've been tossing around a few ideas and trying to figure out what would be the best/easiest.. please give your feedback:
A) Cross thread the nut down as much as possible using some sort of hi-temp thread sealer/hi-temp sealant/cement on it to try to keep exhaust gases from leaking
B) Cut the EGR tube and HOPE that the nut actually fits after having more movement, then put a penny in the nut to seal it off at the header, then put in a plate to block off the EGR at the intake (main question here is, what about those vacuum lines, or whatever they are, attached to the tube? do i just leave them there? etc)
C) Weld shut the opening on the header and do the same for the end of the EGR tube (going to be difficult to do since i don't have a welder readily available and would hafta borrow one from a friend)
P.S. it's an '02 GT 5-speed, and yes, we detached the EGR valve from the intake to give a slight bit more flexibility.
would like to keep the egr system functional if possible.
A) Cross thread the nut down as much as possible using some sort of hi-temp thread sealer/hi-temp sealant/cement on it to try to keep exhaust gases from leaking
B) Cut the EGR tube and HOPE that the nut actually fits after having more movement, then put a penny in the nut to seal it off at the header, then put in a plate to block off the EGR at the intake (main question here is, what about those vacuum lines, or whatever they are, attached to the tube? do i just leave them there? etc)
C) Weld shut the opening on the header and do the same for the end of the EGR tube (going to be difficult to do since i don't have a welder readily available and would hafta borrow one from a friend)
P.S. it's an '02 GT 5-speed, and yes, we detached the EGR valve from the intake to give a slight bit more flexibility.
would like to keep the egr system functional if possible.