Blackouts

xxrequiemxx · Dec 20, 2007

So I just bought the GTS black outs for my car... My car is black so I am trying to "black out" everything on the exterior as much as possible.

Does anyone know if they sell black outs for all the other lights on the car? For instance the side blinker, or the round fog lights in the middle of the grill?

Also - do they make a "smoked" or black GT emblem for the rear of the car which sits dead center of the trunk?

Thanks!
NIck

bigcat · Dec 20, 2007

a smoked front side marker is available & the fog covers are available. i dont know about the rears. i know clear are available, but not sure on smoked.

i have also seen the black rear medallion, but dont remember where. hopefully someone will remember and post up!

08cali · Dec 20, 2007

i think you need to paint the medallion on the trunk.Not sold any other way

xxrequiemxx · Dec 20, 2007

I found the fog's - anyone know where they have the smoked sides?

stanmckinney · Dec 20, 2007

Should look great, but probably 100 percent illegal. Check with local law enforcement if you want to avoid problems.

kooldawg6 · Dec 20, 2007

Emay painted his faux gas cap matte/flat black to blend in.

xxrequiemxx · Dec 21, 2007

stanmckinney said:
Should look great, but probably 100 percent illegal. Check with local law enforcement if you want to avoid problems.

I think they are illegal... but oh well... better than getting a ticket for going 100 mph! (though I never go that fast )

Also - i am a volunteer fire fighter on LI and have special license plates. Cops on Long Island are usually pretty cool with leaving us alone.

xxrequiemxx · Dec 21, 2007

kooldawg6 said:
Emay painted his faux gas cap matte/flat black to blend in.

That is soooooo nice! Is that the GT-500 spoiler? What are those "wings" off the the side on the fender? I just got the GT-500 spoiler on my car and those side wings on the fender would look great.

stanmckinney · Dec 21, 2007

I'd like to know how that fake cap was painted without covering the lettering.

xxrequiemxx · Dec 21, 2007

I would say a REALLY good masking job.

99GTtony · Dec 21, 2007

autobadges sells what you are looking for.

Emay · Dec 21, 2007

Hey guys,

Let me catch up on those questions.

The spoiler is the cervinis ducktail it is not a GT500 spoiler.

The gas cap was pianted flat back by me. I simply took my time masking the piece off. Lightly scuffed it with 1500 grit sand paper, two coats of primer with a light wet sand between and 3 coats of flat black.

stanmckinney · Dec 21, 2007

Looks great. I can't imagine having the patience to do that.

Emay · Dec 21, 2007

Stan I normally don't I'm not the patient type, however, I couldn't very well have it chip and be an eyesore. I won't be embarking on any painting in the future, I'll be giving them to someone else. I didn't enjoy it enough to do it again.

xxrequiemxx · Dec 23, 2007

So I've had these on my car for a few days now.... I love the way they look - but not how secure they seem to stay on.

Does anyone use front/rear blackouts by GTS? If so - do you have the same problem?

dmaxstang · Dec 23, 2007

xxrequiemxx said:
So I've had these on my car for a few days now.... I love the way they look - but not how secure they seem to stay on.

Does anyone use front/rear blackouts by GTS? If so - do you have the same problem?

Not a problem for me anymore, my black Gt has front, rear, and side marker blackouts. The fronts and rears were coming off but i put a small square of velcro tape just inside the GTS cover and put it on and haven't a much as had a shifting in the covers since then. If you black out the fogs, you won't be able to see to drive at night with them on. Leave the fogs off and just the head lamps covered and you can see just fine.

99GTtony · Dec 23, 2007

Just use the 3M velcro on their tape, shouldn't have a problem.

xxrequiemxx · Dec 24, 2007

DOH!

Should have thought of that! Thanks again guys!

xxrequiemxx · Jan 2, 2008

Does anyone know what the velcro is called that comes with the GTS blackouts? It not normal velcro - its more of a secure lock velcro made out of plastic.

Any info is appreciated.

xxrequiemxx · Jan 2, 2008

Nevermind - I found out that its called 3m dual-lock.

Blackouts

Member

start with the upper hole, and if more traction is

Member

Member

mine works really well and can take a fair amount

Attachments

Member

Member

Attachments

Member

Member

Member

Member

Member

New Member

Member

Member

Member

Member

Similar threads

Privacy & Transparency

Privacy & Transparency