If anyone could give me some info i would appreciate it... I just bought a used bd-11 on ebay for my 5.0, and I hardly know anything about superchargers.
The kit I'm getting isn't complete. It has the brackets, head unit, belt. It needs the "down pipe" (I think it's called..goes from the charger to the intake) needs air filter, and I believe I need a fmu.
My 91 5.0 has the following mods that would pertain; BBK 190 in tank fuel pump, electric fan(any clearance issues?) 94-95 130 amp alt(shaved a bracket to make fit), bbk equal length shortys, 24# injectors with calibrated 75 mil proflo mass air, 70 mil bbk tb, performer rpm I upper and lower intake, performer heads, custom ground iske cam for boost, underdrive pulleys, 3 core rad..
I'm running a totally stock bottom end and all ac is still hooked up. Stock balancer. Im running stock ignition too with no chip or mods to the computer and I'm on a budget.
Ok, my questions are;
-do I need a fmu for sure and whats the cheapest way to get one
-whats the best and least expensive way to get that tb intake pipe (who makes and or sells them?), and blow off valve if I need one..(Im planning on running 8-9 psi)
-am I ok running 9psi with my heads?(my compression is around 9to1)
-Are 24# injectors and 190 lph fuel pump ok for that boost level?
-would I really benefit from a boost controler?
-where can I get a copy of the install instructions?powerdyne site doesnt have them.
I would REALLY appreciate any info from someone that knows about this stuff..
The kit I'm getting isn't complete. It has the brackets, head unit, belt. It needs the "down pipe" (I think it's called..goes from the charger to the intake) needs air filter, and I believe I need a fmu.
My 91 5.0 has the following mods that would pertain; BBK 190 in tank fuel pump, electric fan(any clearance issues?) 94-95 130 amp alt(shaved a bracket to make fit), bbk equal length shortys, 24# injectors with calibrated 75 mil proflo mass air, 70 mil bbk tb, performer rpm I upper and lower intake, performer heads, custom ground iske cam for boost, underdrive pulleys, 3 core rad..
I'm running a totally stock bottom end and all ac is still hooked up. Stock balancer. Im running stock ignition too with no chip or mods to the computer and I'm on a budget.
Ok, my questions are;
-do I need a fmu for sure and whats the cheapest way to get one
-whats the best and least expensive way to get that tb intake pipe (who makes and or sells them?), and blow off valve if I need one..(Im planning on running 8-9 psi)
-am I ok running 9psi with my heads?(my compression is around 9to1)
-Are 24# injectors and 190 lph fuel pump ok for that boost level?
-would I really benefit from a boost controler?
-where can I get a copy of the install instructions?powerdyne site doesnt have them.
I would REALLY appreciate any info from someone that knows about this stuff..