brightest headlights available?

tommy_1812

New Member
Dec 21, 2005
41
0
0
Kerrville, TX
I am wondering what the brightest available headlights are for my 1990 mustang. I would prefer something that has a very bright highbeam filament. I've heard that 80 to 100 watt bulbs can be found and installed. Would I need to get a relay for the headlights?

I am willing to use offroad highbeams if possible.

Too many people around here with their new vehicles and insanely bright high beams. Inconsiderate people who don't turn their high beams off at oncoming traffic has pushed me too far. I am looking for something that is potentially blinding, and only used when no cars are around, or at drivers who fail to switch to low beams when oncoming to me. That will make them think twice about being inconsiderate.

Any suggestions would be helpful.
 
you may consider HID retrofits, which can be pricey, but offer the brightest light. only downside is there either is no high beam setting, or it's already bright enough not to need one


IMO, blinding drivers who are in turn blinding you doubles the safety risk of passing eachother, so be an idiot if you must, but don't get pissed when someone runs into your side of the road due to your bright beams
 
I have the same issue, but still run stock wattage bulbs. Seems to me that Silverstars are about as good as you can do Bulb-wise.

You definately would want to upgrade the wiring and install relays for such wattage (the switchgear wont handle that many watts/amps).

Couple other things come to mind. Be careful - you could melt your plastic lens housings. Another means to help is with some killer driving lights. I rum some that are illuminate better than the headlights do, and the beam is lower so it should not distract oncoming drivers.

On a 2G alternator, I noticed that having relays on low beams, high beams, and fogs helped output a noticeable amount. It also saves switchgear and diminishes the amount of dimming at hot idle.

And a 3G noticeably increased the light output across the board by a LOT IMHO.

Good luck.
 
tommy_1812 said:
That will make them think twice about being inconsiderate.
I sincerely doubt that blinding them will make them think twice about "being inconsiderate". What is more likely to happen is that they will become temporarily blinded and crash into you. Then it is you who will be thinking twice about intentionally blinding oncoming traffic.
 
I have a set of BMW hid projectors retrofitted into my car. I have both high and low beam function. The light output is rediculous. It was a total pain in the ass to do and costed around 400 dollars. Well worth it to me though when I'm driving through tiny little streets in the middle of the woods.
 
Check with this guy. Not sure how much you want to spend but......

Here is what our kits look like....
hid_conv_kits_large.jpg


Installation: simple plug and play installation takes less than 30 minutes. No cutting or splicing of wires. Go back to stock just as quickly.

Warranty: All kits include 1 year manufacturer warranty. Anything goes wrong with the kit, they replace the entire unit for free.

Fitment: I have HID kits for most all cars. Let me know which kind of vehicle you have and I will check to make sure we carry a kit for it. Most likely, we will have it. We carry 6000K (pure white color), 8000K (blueish/white color), and 10000K (pure blue color) kits.

Pricing: On my site the kits go for $325 shipped.
If you have any questions, please feel free to ask. Thank you. If would like to just go ahead with a purchase, Paypal accepted at: [email protected] or call me:240 876 9705 or email me: [email protected] to arrange a personal delivery. Thanks again!
__________________


www.stangmods.com
 
I've found a different solution to this issue. Everytime an oncoming car approaches on the highway, I turn my brights off to be considerate. The oncoming car has 2 choices. Most turn their brights off in turn. A few don't. I then turn my brights on and leave them on untill they turn them off (realizing their error at the last minute), or they leave them on and I keep my brights on the whole time.

Most are conscious about this and they turn the brights off right away. You can always tell their brights are on by looking at the intensity, coverage of their beam, and angle of it. There's a few cars who I won't be able to tell if they have their high beams on or not, if the light isn't bothering me, I will leave my low beams on.

The few who don't give a ****, obviously know they have their highs on, when other people flash them (I don't flash, I just flick my highs on untill they lower theirs), and they continue to leave them on. They'd rather see well at the expense of others.

For a $80 investment last month, I purchased a 3 million candle power Industrial spot light for my night job. I only had to use it once in my car so far last night. Someone in an Escalade or Navigator SUV had their brights on half a mile down the highway. I turned my brights off as we got closer as common courtesey. They didn't turn their brights off. The lights started getting to my eyes, and I flicked my brights on. Within a 1/4 mile, they had the nerve to flash their brights at me several dozen times, while leaving them on. The lights were really getting my eyes, so I grabbed my fully charged spotlight and got almost 10 seconds of shining this light at the driver.

As they drove by, I got a view at the driver and passenger (possibly some in the back), looked like 2 punk kids, driver was holding his hand by his face probably from the spotlight, they layed on the horn as we both passed, and they pulled over to the side of the road. I saw it was either a navigator or escalade. They pulled a hard U-turn and were swerving, obviously pissed. They were flashing their brights fast and furious as me and I dropped to 4th, got over a few hills and hooked right onto a street I knew, drove a few miles to another side of town.

Moral of all this? There are people who insist on driving with their brights on. If someone else has the nerve to try and take away that comfort of seeing really far ahead, they will flash their brights several times. This is not the first time that someones flashed me because I flashed my brights at their already high beams. It is the first time I got to give them a taste of their own medicine, and I didn't have to spend more than 40 bucks!

Any of you would probably do the same thing because high beams on these new luxery SUVs are insanely bright! I was seeing spots because of those aholes. Their low beams (the ones I saw for split second intervals) seemed to be much more pleasant.
 
tommy_1812 said:
I've found a different solution to this issue. Everytime an oncoming car approaches on the highway, I turn my brights off to be considerate. The oncoming car has 2 choices. Most turn their brights off in turn. A few don't. I then turn my brights on and leave them on untill they turn them off (realizing their error at the last minute), or they leave them on and I keep my brights on the whole time.

Most are conscious about this and they turn the brights off right away. You can always tell their brights are on by looking at the intensity, coverage of their beam, and angle of it. There's a few cars who I won't be able to tell if they have their high beams on or not, if the light isn't bothering me, I will leave my low beams on.

The few who don't give a ****, obviously know they have their highs on, when other people flash them (I don't flash, I just flick my highs on untill they lower theirs), and they continue to leave them on. They'd rather see well at the expense of others.

For a $80 investment last month, I purchased a 3 million candle power Industrial spot light for my night job. I only had to use it once in my car so far last night. Someone in an Escalade or Navigator SUV had their brights on half a mile down the highway. I turned my brights off as we got closer as common courtesey. They didn't turn their brights off. The lights started getting to my eyes, and I flicked my brights on. Within a 1/4 mile, they had the nerve to flash their brights at me several dozen times, while leaving them on. The lights were really getting my eyes, so I grabbed my fully charged spotlight and got almost 10 seconds of shining this light at the driver.

As they drove by, I got a view at the driver and passenger (possibly some in the back), looked like 2 punk kids, driver was holding his hand by his face probably from the spotlight, they layed on the horn as we both passed, and they pulled over to the side of the road. I saw it was either a navigator or escalade. They pulled a hard U-turn and were swerving, obviously pissed. They were flashing their brights fast and furious as me and I dropped to 4th, got over a few hills and hooked right onto a street I knew, drove a few miles to another side of town.

Moral of all this? There are people who insist on driving with their brights on. If someone else has the nerve to try and take away that comfort of seeing really far ahead, they will flash their brights several times. This is not the first time that someones flashed me because I flashed my brights at their already high beams. It is the first time I got to give them a taste of their own medicine, and I didn't have to spend more than 40 bucks!

Any of you would probably do the same thing because high beams on these new luxery SUVs are insanely bright! I was seeing spots because of those aholes. Their low beams (the ones I saw for split second intervals) seemed to be much more pleasant.

:Teh-Win:
 
Nice, I had some punk kids flash one of those flashlights at my fiance and I as they passed us. Then the ****er leaned out the window to get us from in front while the driver braked hard. Dunno why, probably thought it was funny.

He was lucky that my girl calmed me down cause I had my 38 and I was getting ticked to say the least.

I did get his plate number though... was gonna turn it in but I think it will be even better to keep it in case i ever run into him again....

Moral of this story. You never know who has a gun, so don't you think it might be better to just take one. Let the *******s be *******s and not lower yourself by playing thier games.
 
If you want to understand a bit more about lighting systems, I've found this site useful ... http://www.danielsternlighting.com/home.html

I upgraded my '4 eye' configuration with European Hella H1 and H4 lights, added relays and 10ga/12ga wiring to eliminate the drop from alternator to bulbs, and installed 80w/100w H4 bulbs, and 100w H1 bulbs. It is bright -- properly aimed they don't tick anyone off and I've got 0.00V drop between the alternator and the bulb that's furthest away.

Simply adding high wattage bulbs without upgrading the wiring and installing relays will generally fry fuses if not your wiring and light switches. Part of the reason for poor performance of stock systems is due to the voltage drop that occurs just getting current to the stock bulbs. Relatively small wiring runs from the source (alt/battery) inside the car to the switch and back out to the bulbs. It's not uncommon to lose 2-3 volts just getting to the bulb -- and that shows up as 30-50% reduction in lighting output. Relays/bigger gauge wiring helps a lot even if you don't upgrade bulbs. Be careful though -- I think y'all are dealing with plastic housings that have a limit as to how much heat they can take. Mine are all glass/steel - so I can turn the flame-throwers on. ;)
 
Michael Yount said:
Be careful though -- I think y'all are dealing with plastic housings that have a limit as to how much heat they can take. Mine are all glass/steel - so I can turn the flame-throwers on. ;)

Those plastic housings (atleast the Ultra Clear) from 50RESTO don't fair well to the added heat of the 80/100 9004 bulb as I verified in a previous post. It really sucks because the output was great from them. So I just stick with the Silverstars and harness upgrade which have a pretty decent output.
 
blackcloud50 said:
Those plastic housings (atleast the Ultra Clear) from 50RESTO don't fair well to the added heat of the 80/100 9004 bulb as I verified in a previous post. It really sucks because the output was great from them. So I just stick with the Silverstars and harness upgrade which have a pretty decent output.

If you have Silverstars that have the same rating as stock bulbs, why would a extra wiring harness be needed?
 
Shaker, I think he upgraded the harness when he used the higher-drawing bulbs (80/100's). But since his lenses went south after that, he now just runs the Silverstars on the existing upgraded harness (the harness was not upgraded just for Silverstars).
 
I believe you'll find that a harness upgrade with relays will do more for your lighting output than putting a set of Silverstars in with no harness upgrade. Take your voltmeter with the car idling and headlights on -- measure the voltage at the alterntor output; measure the voltage at the headlight bulb. The difference is the drop through the stock harness and it SIGNIFICANTLY impacts output - see the link in my post above for a great explanation of this.

However - the biggest problem with lighting on these cars (later model Volvos have the same issue) is the plastic lenses become cloudy/yellowed. And when they do, you can upgrade the harness and put big-watt bulbs in --- but the light can't penetrate that cloudy plastic lense. So if your lenses aren't "see-through-new" looking - don't bother with upgrading what's behind it.
 
Michael Yount said:
I upgraded my '4 eye' configuration with European Hella H1 and H4 lights, added relays and 10ga/12ga wiring to eliminate the drop from alternator to bulbs, and installed 80w/100w H4 bulbs, and 100w H1 bulbs. It is bright -- properly aimed they don't tick anyone off and I've got 0.00V drop between the alternator and the bulb that's furthest away.

I did this same upgrade with my 86 and the light output is nearly as good as my 2005 F250. I would recommend to anyone with a 4-eye car to do this upgrade.:nice: