• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Built new engine - will not start

  • Thread starter Thread starter moonenn3186
  • Start date Start date May 1, 2004

moonenn3186

Founding Member
Jan 9, 2002
233
0
0
Dubuque, Iowa
May 1, 2004
#1
  • May 1, 2004
  • #1
So I finally got everything ready to go on the new 351w this morning. Turned the key and it started - idled at 2K for a few seconds, so I turned it off. Checked everything - unhooked the electric fuel pump (not sure why) - turned the key and it started again and idled at 850 rpms till the carb ran out of gas.

Now it will not re-start. . . I have never had this happen. MSD 6al, Reman Duraspark distributor, electric fuel pump (still working), Holley double pumper...

I have checked and rechecked top dead center - set the rotor on the 1 cylinder, set initial timing at 10* - anyone have some ideas?
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
May 1, 2004
#2
  • May 1, 2004
  • #2
i would think you need to prime the fuel pump again. are you getting fuel into the bowls now? if not, re-purge it.....my best guess. good luck.
 

moonenn3186

Founding Member
Jan 9, 2002
233
0
0
Dubuque, Iowa
May 2, 2004
#3
  • May 2, 2004
  • #3
I am getting fuel out of the squirters . . . and I am getting spark. I can't keep cranking on this thing or I will round of my non-roller cam...

Should I dump gas down the carb? That is what I am about to do . . . how much gas does thing thing need to start?
 

BarnStang

Founding Member
Mar 2, 2001
1,260
3
39
Hagerstown, MD
May 2, 2004
#4
  • May 2, 2004
  • #4
Not much! If you have not done this before with a carb (especially one that's being difficult) you cannot understimate the danger of gasoline. Consider how much the accelerator pump squirts in there. More than a sprinkle, less than a splash.
When I was still in the service, I read in a safety bulitin about an guy who was off duty doing eactly what you are contemplating. He held the cup of gasoline in his hand while his buddy stried to start the car. It backfired and he was set on fire. He survived. However, it's done all the time. And is an easy fix for stubborn carb motors sometimes. Common sense should prevail.

If it ran once, it should run again. I would consider that its flooded. Hold the gas pedal to the floor while you crank it to get air flowing through to evaporate the excess fuel. This "usually" works. Try this before adding more fuel to the fire. Make sure the plugs are actually dry and not wet with fuel befor tossing gas in the carb.
 
T

TheUser

Active Member
Jul 25, 2003
1,859
1
36
Springfield, MO
May 2, 2004
#5
  • May 2, 2004
  • #5
thumper460 comes to mind...he might have some ideas. Good luck, this will bump you up too....about to fall off...the ideas above sound good too
 

moonenn3186

Founding Member
Jan 9, 2002
233
0
0
Dubuque, Iowa
May 3, 2004
#6
  • May 3, 2004
  • #6
As it turns out - the plugs were oil fouled! Over the course of the build I kept putting oil on the cylinder walls to prevent moisture...must have had to much! Cleaned em and she fired immediatly . . .

12 minutes into the cam break in however, my radiator sprung a leak (damn electric fan rubbed through - couldnt hear the tick with the car running at 2500 rpm!)

Thanks for your help everyone
 
You must log in or register to reply here.

Similar threads

A
1987 5.0 speed density Foxbody crank no start
  • Alan2204
  • May 23, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
319
Fox 5.0 Mustang Tech May 30, 2026
Mcmahst
8
Electrical Crank-no start ... no spark ... no injector pulse, was it something I did? (redux)
  • 85gtCOBRA
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
578
Fox 5.0 Mustang Tech Oct 29, 2025
85gtCOBRA
8
8
Engine Rough idle and aggressive sputtering when accelerating
  • 88vertible
  • Aug 13, 2025
  • Fox 5.0 Mustang Tech
Replies
4
Views
1K
Fox 5.0 Mustang Tech Dec 13, 2025
Jarhead67
J
1999 Mustang GT - No Start- Need help understanding the fuel pump circuit and how it works
  • 99gtGuy
  • Nov 4, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
536
1996 - 2004 SN95 Mustang -General/Talk- Nov 7, 2025
04newedge-
0
B
'03 GT Fuel Pump/Pressure/Delivery Issue
  • Brodach
  • Oct 21, 2025
  • SN95 4.6L Mustang Tech
Replies
8
Views
926
SN95 4.6L Mustang Tech Oct 31, 2025
gkomo
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?