Can't find the keyless entry module

[jwater7]

2 questions:

Well, I finally got my drivers-side door switch in, and did the old "lock the door, lift up on drivers-side door handle, and check to see if dome light turns on" test.
It does in fact turn on, so it makes me think that I've got keyless entry...however, I can't find the module.
Someone said that I should check inside the trunk under the "carpeting" by the rear lights, and also check by the drivers' feet. But I have not seen it.
1) Where could it be, if I even have one? If I had some wiring diagrams, I could trace the wires...

2) after a while, the dome light shuts off (like I've heard it should), and will turn on with a "door open" or "handle lift". However, if I leave the car for a while (like overnight) and come back to it, the light will not turn on again until I either turn the headlights on, or turn the key to the on position. Any ideas?

Thanks.

 

[Rootus]

The module is just behind and above the rear driver side wheel well. You'll have to pull back the trunk liner on that side to see it.

 

[jwater7]

aha, I found it...

Now I guess I've got to get a remote...

still no ideas on the dome light shutting off?

Thanks Rootus

 

[jwater7]

anyone have the FCC ID for the remote?

nm, this is probably a separate thread...

 

[jwater7]

ok, so since after a thorough search, I coudn't find any pictures of where it was, and it's a bit hidden...I decided to attach a picture of where the keyless entry module is, and what it looks like...so here it goes..
<IMG SRC="http://img59.exs.cx/img59/2539/IM001766.jpg" width=500>

 

[jwater7]

you've also got to be smarter than the dang plastic bolt that attaches the plastic mount, so here's a picture of it to help you out.

<IMG SRC="http://img64.exs.cx/img64/2567/HPIM0213.jpg" width=500>

 

[jwater7]

Still confused about the dome light though, any ideas?

 

[jwater7]

I want to be able to remove those pictures from "my attachments" but I think they're quite useful for the next person that can't figure it out...does "inlining" the pictures, like i've seen on other threads, save them perminantly?

NM, okay, I see how everyone is doing it, they're off-site images...I'll have to set them up somewhere...

BUT, still have problems with the dome light issue...