O.K. so today I decided to to move 4 hot wires which are for my nitrous stuff from the positive post of the battery to the one side of the solinoid where everything else is. I then took 2 ground wires off my negative post of the battery and grounded those to the chasis. I go to start the car and it just cranks. So I look to make sure everything is hooked up and I find no loose wires anywhere other than ones that have always been disconnected. So I turn the key forward again and I realize my fuel pump isn't kicking on. So I pull the relay under the drvs seat for the fuel pump and bypass it to see if it will kick on and it does. So I go over to the relay for the computer under the dash and start tapping it with a screwdriver while the key is turned forward and that did nothing. I checked the voltage on what I beleive is the power wire to that relay with the key turned forward and I am getting no voltage. The wire I checked was a 10 ga orange and black wire. I also did the same up on the silinoid and I have voltage up there. But for some strange reason my fuel pump will not kick on. I went out and bought another silinoid tonight and that did nothing either. I need some help here guys. I couldn't even begin to tell you what wires are what on the silenoid so I really don't even know where to begin. Also I did have the battery disconnected when I moved the wireing from it to the silenoid.