I recently had my subframe connectors welded on at a muffler shop. The shop had one of the lifts that you drive the car up on, so the car was sitting on its 4 wheels when he welded them in. Now the right side is sitting about 3/8" higher than the left side. Before the subframe connectors were welded in, the car was level. Should I be concerned or will the car eventually settle down to the way it was before? I looked under the car and the subframes look like they are welded in the same on both sides. I have a 1992 convertible with complete Steeda stage 3 G-Trac suspension (sport springs, upper and lower control arms, g-trac brace, subframe connectors, stb, Tokico 5-ways, c/c plates).