• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

car still cranking over with keys not in car??

  • Thread starter Thread starter jmd2914
  • Start date Start date Sep 12, 2006
  • 1
  • 2
Next
1 of 2 Next Last
J

jmd2914

Founding Member
Sep 6, 2002
937
0
0
Napa, California
Sep 12, 2006
#1
  • Sep 12, 2006
  • #1
i went out and started my car and i could hear something was very wrong when i started it so i took the key out but when i took the key out my car was still craking over, it wouldnt rev when i pushed the gas in but the belt was still moving and the starter ( i think) was still cranking. should i replace the starter? help!! i have to work tomorrow
 

TC93

Well-Known Member
Sep 11, 2000
2,075
1
57
Ellerslie GA 31807
Sep 12, 2006
#2
  • Sep 12, 2006
  • #2
It could be the starter relay sticking. Try tapping on it when the starter stays engaged liek that. If it stop, then go with a starter relay..
 

Fett

New Member
Nov 2, 2004
766
6
0
Sep 12, 2006
#3
  • Sep 12, 2006
  • #3
Yea, sounds like starter relay. Do what Myke86GT said. Then replace the relay, as it will stick again.

You may want to look into upgrading to the 95 starter, all you need to do is move a few wires, and run a trigger wire to the starter and you will never have this problem again.
 
J

jmd2914

Founding Member
Sep 6, 2002
937
0
0
Napa, California
Sep 12, 2006
#4
  • Sep 12, 2006
  • #4
so its the relay up on the drivers side fender
 

TC93

Well-Known Member
Sep 11, 2000
2,075
1
57
Ellerslie GA 31807
Sep 12, 2006
#5
  • Sep 12, 2006
  • #5
jmd2914 said:
so its the relay up on the drivers side fender
Click to expand...

Yep, right by the coil with all the wire hooked to it.. Just be sure to hook all of them back up and on the correct lugs.. Take a pic or write down what goes where if you are unsure..
 

06stangtyme

New Member
Feb 4, 2006
21
0
0
Nashville
Sep 12, 2006
#6
  • Sep 12, 2006
  • #6
A very low battery start can cause the relay to stick as well....
 
J

jmd2914

Founding Member
Sep 6, 2002
937
0
0
Napa, California
Sep 12, 2006
#7
  • Sep 12, 2006
  • #7
ive replaced it before cuz it burnt out, so i think i have a spare one at the house, should i still replace the starter?
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Sep 13, 2006
#8
  • Sep 13, 2006
  • #8
Another solenoid vote. Very unlikely that it's the starter [bendix hanging up].

And the comment about low battery charge is spot on.

You can do quick diagnostics with the starter cable at the solenoid if desired.

Good luck.
 
J

jmd2914

Founding Member
Sep 6, 2002
937
0
0
Napa, California
Sep 13, 2006
#9
  • Sep 13, 2006
  • #9
do you guys think it burned out the starter? having it just crank and crank? how do i tell if it is burned out? ( dumb question)
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Sep 13, 2006
#10
  • Sep 13, 2006
  • #10
How long did it crank for? Any nasty smells or smoke?
 
J

jmd2914

Founding Member
Sep 6, 2002
937
0
0
Napa, California
Sep 13, 2006
#11
  • Sep 13, 2006
  • #11
no nasty smells or smoke, but it cranked until my battery died. how hard is it to change my starter?
 

MahFiVeOh

Founding Member
Apr 26, 2002
531
9
49
Ontario, Canada
Sep 13, 2006
#12
  • Sep 13, 2006
  • #12
Tap your relay with a small hammer or something like that and it should stop, you dont want to let it crank till the battery dies.Does it stick every time you go to crank it over? I had the very same problem with my car.

Check your PM's.
 

MahFiVeOh

Founding Member
Apr 26, 2002
531
9
49
Ontario, Canada
Sep 13, 2006
#13
  • Sep 13, 2006
  • #13
.....check your PM's again.
 
W

wazazzle

New Member
Mar 30, 2005
618
1
0
In the dumpster behind McDonalds. WA
Sep 13, 2006
#14
  • Sep 13, 2006
  • #14
i had the same thing happen to me once. some idot i took my car in to get the starter checked out by the garage that installed it. well the mechanic was starting my car a few times and fried my starter relay. the car just kept cranking and cranking and cranking. so i disconnected the relay and told the mechanic to get the F out and never touch my car again. needless to say although the starter is still covered by their warrenty i will never go back to them again. and yes i had to replace the relay $12, starts find now.
 
J

JDnyc

New Member
Mar 1, 2004
5
0
0
BRONX NYC, NY.
Sep 14, 2006
#15
  • Sep 14, 2006
  • #15
BUY A NEW SELONOID. MAKE SURE YOU GET A MOTORCRAFT SELONOID , BECAUSE ALL OF MY EXPERIENCE WITH AFTERMARKET ONES WERE REAL BAD. THEY ONLY LAST 2 DAYS AT MOST.
 

TRWXXA

Member
Jan 18, 2003
190
1
19
RIGHT BEHIND YOU!!!... Made you look.
Sep 14, 2006
#16
  • Sep 14, 2006
  • #16
I'd plan on replacing the starter in the near future.

Starter motors work very hard, and generate a lot of heat very quickly. You should not run a starter for more than about 30 seconds (total cranking time) without giving it 5 minutes or more to cool down.

You've probably lost a couple of years off the life of your starter because of the prolonged, continuous cranking.
 

dragnazz5.0

My "0" key d0esn't w0rk, s0 I have t0 use the zer0
Nov 19, 2005
815
5
18
mooresville, nc
Sep 14, 2006
#17
  • Sep 14, 2006
  • #17
just to let you know, my buddy had the same problem with his car a few years ago and we swapped my solenoid onto his car to see if that was it and it still did it. turned out it was the starter.
 
P

postalbunny

Member
Oct 26, 2005
118
0
17
Sep 15, 2006
#18
  • Sep 15, 2006
  • #18
dragnazz5.0 said:
just to let you know, my buddy had the same problem with his car a few years ago and we swapped my solenoid onto his car to see if that was it and it still did it. turned out it was the starter.
Click to expand...

Not sure how the starter could still be cranking /w a good realy... the relay would have cut the pos juice. The relay has to feed it juice, it has no other way to turn over. Mabey a bad starter fried the relay... by pulling to much juice and not moving etc.

More likely your bad relay burned the starter out by causing it to crank to much. I've had a relay do this a few times and continue to work properly for a year and then go out again. It eventually went out. Be warey of that relay, if you havn't replaced it when the starter went down... cheap part to replace, like $10.
 

06stangtyme

New Member
Feb 4, 2006
21
0
0
Nashville
Sep 15, 2006
#19
  • Sep 15, 2006
  • #19
Just change the darn relay and put a Good battery (fully charged) in it and drive the thing.....If the voltage drops below 9 volts it will cause the relay to stick...GEEESH... View attachment 440206
 
J

jmd2914

Founding Member
Sep 6, 2002
937
0
0
Napa, California
Sep 15, 2006
#20
  • Sep 15, 2006
  • #20
i replaced the relay and it runs fine
 
  • 1
  • 2
Next
1 of 2 Next Last
You must log in or register to reply here.

Similar threads

M
85 mustang 5.0 cranking in run position
  • Mamaclean
  • May 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
148
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 1, 2026
General karthief
C
Electrical HELP! 1989 5.0 Stick, Voltage Bleed onto Ignition Trigger wire
  • ChickenDeluxe
  • May 14, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
247
Fox 5.0 Mustang Tech May 24, 2026
ChickenDeluxe
C
8
Electrical Crank-no start ... no spark ... no injector pulse, was it something I did? (redux)
  • 85gtCOBRA
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
574
Fox 5.0 Mustang Tech Oct 29, 2025
85gtCOBRA
8
Fox won't crank over and fuel pump won't kick on.
  • djj62478
  • Jun 7, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
16
Views
361
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 11, 2026
General karthief
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
273
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?