• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Car will not shift into 2nd

  • Thread starter Thread starter 885.0conv
  • Start date Start date Feb 11, 2008
8

885.0conv

Member
Jan 9, 2008
238
0
16
Phoenix, Az
Feb 11, 2008
#1
  • Feb 11, 2008
  • #1
I took out my tranny (AOD) to replace the rear main seal. Made sure that the fluid levels were good after shifting through all the gears. The tranny was slipping at first which I assume is normal until the fluid gets moved around. The slipping eventually disappeared. When I took it around the block the car would not shift into 2nd. I was driving it slowly (about 20-25) usually the car would shift around that speed. Also I installed a high stall converter (2000-2400). I was wondering how long is the break in time and if it is ok to push it a little harder since I changed the torque converter. Also there was some smoke but I did get a lot of oil and grease on the exhaust when I was taking it out. Thanks again
 

NKau

Founding Member
Dec 15, 2001
1,346
0
37
Jefferson, WI
Feb 11, 2008
#2
  • Feb 11, 2008
  • #2
Are you sure you properly adjusted your tv cable upon reinstallation? This is critical, and you can quickly wreck an AOD by driving around with one that is not adjusted right.
 
8

885.0conv

Member
Jan 9, 2008
238
0
16
Phoenix, Az
Feb 11, 2008
#3
  • Feb 11, 2008
  • #3
how do you go about adjusting it
 

NKau

Founding Member
Dec 15, 2001
1,346
0
37
Jefferson, WI
Feb 11, 2008
#4
  • Feb 11, 2008
  • #4
I don't know how to adjust them myself as I don't own a car with an AOD..... Hopefully someone will chime in here. May want to do a search, or scope out the link below

http://www.txchange.com/aodadj.htm

Good luck.
 
8

885.0conv

Member
Jan 9, 2008
238
0
16
Phoenix, Az
Feb 11, 2008
#5
  • Feb 11, 2008
  • #5
Thanks, that should help me out.
 

mustangfan1990

New Member
Jul 17, 2005
505
1
0
Lenoir, North Carolina
Feb 11, 2008
#6
  • Feb 11, 2008
  • #6
It has been a while since my car was an AOD cause I converted to a manual, but if I remember something right I think you hold down the gas pedal and tighten it from there, I could be wrong though like I said it has been a while!!!
 

baldy1

New Member
May 5, 2005
124
0
0
Portsmouth Va
Feb 11, 2008
#7
  • Feb 11, 2008
  • #7
If you didnt disconnect the TV cable from the throttle body than you shouldnt have to adjust it. Have you check the fluid since you put a different converter in. You said it was slipping first then it stopped. Check the fluid level.
 
You must log in or register to reply here.

Similar threads

T
Drivetrain TREMEC TKX 1–2 Grinding Issue at ~4,000 Miles + Poor Warranty/Customer Service Experience
  • Ttopfoxguy
  • Oct 10, 2026
  • Fox 5.0 Mustang Tech
Replies
5
Views
328
Fox 5.0 Mustang Tech Oct 15, 2026
JMG9350
J
S
Drivetrain Downshifting from 3rd to 2nd issue
  • Scott_S
  • Apr 23, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
35
Views
1K
Fox 5.0 Mustang Tech Oct 12, 2026
limp
W
Speedometer and shifting issues
  • wyatt-tetro891
  • Aug 17, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
317
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 18, 2026
wyatt-tetro891
W
D
rpm goes up - car does not speed up.
  • dawakbar
  • Oct 26, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
147
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 27, 2026
nickyb
Drivetrain 83’ Glx convertible C5 Trans help!
  • JacksonJared2113
  • Dec 25, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
536
Fox 5.0 Mustang Tech Dec 26, 2025
JacksonJared2113
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?