charging problem

91stangy

Member
Jun 11, 2003
116
0
16
hey guys having a little charging problem, and its not the alternator, i was just puttin a brand new sn95 into my 87 and its puttin 12.01 to my power cap at idle but when i rev the motor it only put 12 it does not increase. is there anything other than the alternator or could it be the alternator again.
 
Do you have the stator wire properly installed? Without it, the alt will not provide power at all (it will not turn "on"). You're probably reading battery voltage on your readout.
 
all the wires were going to the right places and didnt seem chopped or cut anywhere... but which ground wires are you talking about, also which wire is the stator wire.
 
91stangy said:
all the wires were going to the right places and didnt seem chopped or cut anywhere... but which ground wires are you talking about, also which wire is the stator wire.
Here's websites with pictures of the 3G installation...

See http://www.geocities.com/smithmonte/Auto/3G_130A_Alternator_Upgrade.htm - all the tech data you could ever want to know
OR
http://www.mustangcentral.net/tech/alternator.html - excellent pictures of installation

Use these sites for information on the right way to do the wiring. Some people will tell you that you can skip the wiring upgrade, but it will catch up with you sooner or later. A fire in the wiring harness is ugly and expensive.

Don’t forget the alternator power ground!!!
The secondary power ground is between the back of the intake manifold and the driver's side firewall. It is often missing or loose. It supplies ground for the alternator, A/C compressor clutch and other electrical accessories such as the gauges. Any car that has a 3G alternator needs a 4 gauge ground wire running from the block to the chassis ground where the battery pigtail ground connects.
 
Do make sure the switch-and-sense wire is still attached (it is on the alternator harness which goes to the positive lug on the solenoid - and is the reason we leave that connection in tact [unless you undo the harness and connect that wire directly]).

Good luck.