Chin Spoiler Install
- Thread starter 85MustGT
- Start date
supastang03
Member
use masking tape to hold it up on the front chin of the car. by doing this u can play with it alot and get the chin to the exact spot u want it. after just start drilling it into place (take off masking tape last).
sveet
Founding Member
I just put mine on this morning.
There were 3 push type fastenrs already attached to the spoiler. The fasternes that I bought as a part of the "kit" didn't fit in the first hole on each side, so I moved (2) of the push fastners to the first hole on each side (by the tire).
I simply started at each wheel opening by starting a connection where I wanted it, then went to middle center and attached it. The rest just tightened it all up.
I used a 1/4" drill bit.
There were 3 push type fastenrs already attached to the spoiler. The fasternes that I bought as a part of the "kit" didn't fit in the first hole on each side, so I moved (2) of the push fastners to the first hole on each side (by the tire).
I simply started at each wheel opening by starting a connection where I wanted it, then went to middle center and attached it. The rest just tightened it all up.
I used a 1/4" drill bit.
speed545
Member
85MustGT said:
I installed mine last week. It came with 3 plastic push pin. I bough a buch of ss selftaping metal screw. If you look at a Mach 1, you ll notice that the 2 extremity of the chin spoiler are flush with the bottom of the fender opening. To be able to install your spoiler that way, it wont be flush with the bottom of the bumper but about 1/8'' to the back. I choose to installed it flush with the bumper but extremity are about 1/4'' forward of fender. Dont have to drill if using selftaping metal screws. Masking tape is good idea. I used double side tape and it was a pain to play with the spoiler. It stick so much.
Good luck. You ll see it s easy
Similar threads
