Hey guys. After recently completing an h/c/i 302 and dropping it in, I haven't been able to get the thing to run anywhere near right. In addition to the h/c/i, I also put in 24 lb. injectors, a 65mm tb, and a pro-m maf calibrated for the 24 lbers.
This was partiallly my fault, because I forgot to install the ACT sensor on the new intake (port was filled with a pipe plug when I got it) and I figure that is what led to the CEL and poor running in the first place. Now, after installing the ACT off my old motor, I still am getting CEL's, and the engine still won't idle.
Do I need to reset the computer after installing the ACT? Also, how long should it take for the ECU to adapt to all of the new parts?
This was partiallly my fault, because I forgot to install the ACT sensor on the new intake (port was filled with a pipe plug when I got it) and I figure that is what led to the CEL and poor running in the first place. Now, after installing the ACT off my old motor, I still am getting CEL's, and the engine still won't idle.
Do I need to reset the computer after installing the ACT? Also, how long should it take for the ECU to adapt to all of the new parts?