over the past week i have installed 4.10s, SSM lift bars, lowering springs, and new calipers and rotors. when i drive my car and i give it some gas i get this clunking sound that sounds like it is coming from where my tranny and driveshaft meet. i notice it most when i shift since i get off of the gas and then back on it. it does it every time. i noticed that i had to pull my driveshaft out of the tranny a little bit so that i could bolt it to the rear end. if any one could give me any input on your thoughts about the noise, i would greatly appreciate it.
thanks,
Steve
thanks,
Steve